Ww2.justanswer.com
| |
| |
| |
[pic]
|2000 Honda Truck Passport EX 4WD V6-3.2L DOHC (6VD1) |
| [pic] [pic] |
| |
|[pic] |
|Service and Repair |
| |
| |
| |
|REMOVAL |
|Place selector lever in neutral. |
|Disconnect battery ground cable. |
|[pic][pic] |
| |
|[pic] |
| |
|Top of Form |
|[pic] |
|Bottom of Form[pic] |
|Top of Form |
|[pic] |
|Bottom of Form |
| |
| |
| |
| |
|Remove mode switch cover (1). |
|Disconnect selector lever (2) from the mode switch. |
|Remove bracket with cable (3). |
|Disconnect transmission harness from the mode switch connector (4). |
|Remove bracket with mode switch connector from the transmission case. |
|Remove mode switch connector (4) from the bracket (5). |
|Remove two mode switch bolts and nut then remove mode switch (6). |
|INSTALLATION |
|To install, follow the removal steps in the reverse order, noting the following points; |
|Torque Mode switch bolt: 13 Nm (113 inch lbs.) Selector lever nut: 23 Nm (17 ft. lbs.) |
|Mode switch setting procedure. Perform either of the following adjustment procedures: |
| |
|Procedure 1 |
| |
|Place selector lever in neutral. |
|Remove selector lever from the mode switch. |
|Remove the mode switch cover. |
|Loosen the two 10 mm screws. |
|[pic][pic] |
| |
|[pic] |
| |
|Top of Form |
|[pic] |
|Bottom of Form[pic] |
|Top of Form |
|[pic] |
|Bottom of Form |
| |
| |
| |
| |
|Rotate the mode switch until the slot in the mode switch housing aligns with the selector shaft bushing, and insert a 3/32 inch |
|(2.4 mm) drill bit or punch (1) into the slot. |
|Tighten the screws to 13 Nm (113 inch lbs.) . |
|After completing adjustment, snap the mode switch cover into place. |
|Reinstall the selector lever. |
| |
|Procedure 2 |
| |
|Place selector lever in neutral. |
|Disconnect transmission harness connector from mode switch connector. |
|Remove mode switch connector with bracket from the transmission case. |
|[pic][pic] |
| |
|[pic] |
| |
|Top of Form |
|[pic] |
|Bottom of Form[pic] |
|Top of Form |
|[pic] |
|Bottom of Form |
| |
| |
| |
| |
|Connect multimeter (resistance mode) to terminals 1(E) and 4(H) on mode switch connector. |
|Loosen two mounting screws. |
|Rotate mode switch slightly in both directions to determine the range (approx. 5 degrees) of electrical contact. |
|Position mode switch in middle of contact range. |
|Tighten two mounting screws. |
|Remove multimeter and install mode switch harness connector with bracket to the transmission case. |
|Connect transmission harness connector to mode switch connector. |
| |
|[pic] |
| |
| |
................
................
In order to avoid copyright disputes, this page is only a partial summary.
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.