WordPress.com



TS570 Front and Rear Panel Layout, and Menu Options

By M0AID

1 Top left 2 buttons

1.1 PF (default voice 1) - 55

1.2 Power

2 Top left below top 2, block of 6 in Braille cell arrangement

2.1 ATT, RX attenuator - 37

2.2 VOX - 31 for SSB, 34 for CW

2.3 Send/Receive - 15

2.4 RX Pre amp, - 32

2.5 TX Speech Processer - 37

2.6 ATU,- 52

3 middle of left hand side, 12 key number pad 3 across and 4 down

in style of telephone with 1, 2, 3 at top

3.1 1 and CH1, internal keyer - 34

3.2 2 and CH2

3.3 3 and CH3

3.4 4 and ANT, selects Antenna 1 or 2 - 1 and 48

3.5 5 and Rec, record mode for CW memory - 35

3.6 6 and Fine, reduces tuning steps by a tenth - 30

3.7 7 and NB, analogue noise blanker - 36

3.8 8 and A G C/tone, switch between A G C slow and fast - 30 , sub tones - 24, and CTCSS Function - 25

3.9 9 and Rev, for CW and FSK used to switch between USB or LSB when RX - 21 - 26

3.10 CLR

3.11 0 and F lock

3.12 Enter, press and key in frequency - 29

4 Column of 4 buttons directly left of numeric keypad

these are the transmit function buttons used with the CH dial at bottom right of unit

4.1 MIC, sets microphone gain - 14

4.2 PWR, TX power - 15

4.3 Key, sets internal keyer speed - 34

4.4 Delay, when using VOX, adjusts delay from TX to RX - 31 - 34

5 Directly left of VFO and hugging the curve

5.1 LSB / USB selection - 20 - 27

5.2 CW / FSK, - 21 - 26

5.3 FM / AM -22

6 Directly left of VFO and right at bottom of unit, 2 horizontal buttons

6.1 Menu, selects and cancels menu - 16

6.2 1mHz, selects between 1mHz mode and Amateur band mode - 29

7 VFO

7.1 Tuning dial

7.2 Torque control, fully clockwise for light torque

8 Directly right of VFO 4 horizontal buttons at top

8.1 Minus, steps by 1mHz or by band - 13 - 29, and up and down menu

8.2 Plus

8.3 Quick Memory Recall, press to recall data from quick memory - 45

8.4 Quick Memory In, press to write data into quick memory - 44

9 Directly right of VFO in centre, block of 8 buttons, 2 rows 4 columns

working across first row

9.1 Split, for split frequency TX and RX - 23

9.2 TF set, when operating split frequency, press to monitor or change TX freq - 23

9.3 A/B, selects between VFO A or B - 13, also in menu mode press to select menu A or B - 16

9.4 RIT, on or off - 30

9.5 M/V, selects either memory or VFO mode - 40

9.6 A=B, copies data from currently selected VFO to other VFO - 30

9.7 Clear, resets RIT or XIT frequency to 0 - 30 - 32

9.8 XIT - 32

10 Directly right of VFO at bottom, 3 horizontal buttons

10.1 Scan button, press to start and stop scan function - 46 47

10.2 M>VFO, transfers data from memory to VFO - 32

10.3 M. In, writes data into a memory channel or selects memory scroll mode - 41

11 Top right of unit, column of 4 buttons

11.1 NR, toggles between noise reduction 1, 2, or off - 38

11.2 Beat Cancel, on or off dsp notch filter - 38

11.3 CW Tune, activates zero beat function - 21

11.4 Filter button, changes RX filter band width for SSB, CW, FSK or AM - 36 - 38 or FM, wide or narrow transmit deviation - 22

Press the mode button, SSB or CW, press Filter button and Multi/CH dial to select filter type, then press Filter again to store

12 Bottom right of unit, 2 rotary controls one above the other and below 11.4 the Filter button

12.1 RIT/XIT dial, use in conjunction with 9.4 and 9.8, - 30 - 32

12.2 Multi-CH control, in VFO mode turn to step operating freq up or down - 29, in mem mode selects channel - 40, in menu mode selects menu numbers - 16,

13 Column of 3 dials on far right of unit

12.1 Top inner, DSP slope high, in SSB or AM mode turn anti-clockwise to cut off high frequency with RX pass band, use when higher interference is present - 37

12.2 Top outer, DSP slope low,

12.3 middle inner, AF volume - 13

13.4 Middle outer, RF gain - 13

13.5 Bottom inner, IF control, turn to slide RX pass band lower or higher in frequency when interference present - 36

13.6 Bottom outer, SQL - 14

14 Microphone

14.1 Microphone - 9

Rear panel layout

15 Top left, 2 aerial sockets

15.1 Ant 2, to the left - 1 - 48

15.2 Ant 1, to the right

16 top centre

16.1 AT connector, External ATU

17 Top right

17.1 DC input, 13.8V - 2

18 Far right in middle below DC input

18.1 Ground post

- 2

19 Bottom left

19.1 COM connector - mates with 9 pin female RS232C - 60

20 To right of COM port, 2 key jacks

20.1 Key, mates with 3.5mm plug for external keyer - 3

20.2 Paddle, mates with 6mm conductor plug for connecting to internal keyer

21 Bottom centre, to right of key inputs

21.1 ACC2 connector, mates with 13 pin male din connectorfor connecting various accessory equipment - 61 62

22 Bottom right and one in

22.1 External speaker socket, mates with 3.5mm jack - 3

23 Bottom right

23.1 Remote socket, mates with 7 pin male din connector for connecting linear amp - 61

Menu system - 17

Group, operator interface

00 Display brightness

01 Beep output level, 1 min, 9 max, - 49

Group Encoder

02 Frequency step size for up/down button in 1MHZ step mode, 100Kh, 500kh, 1000Kh, def 1000kh -29

03 Frequency step size for multi/ch control, SSB CW FSK AM modes, 1, 5, 10, def 10 - 29

04 Frequency step size for multi/ch control for FM mode, 1, 5, 10, 12.5, 20, 25, all Kh, def 10Kh - 29

05 Rounds off frequencies changed by multi/ch control, def on - 29

06 Frequency step size for multi/ch control for AM mode in AM broadcast bands, 9Kh, 10Kh, def ?Kh - 29

Group, Memory channel

07 Memory VFO split operation, def off - 41

08 Tuneable on or fixed off memory channel frequencies, def off - 41

Group, Scan

09 Program scan hold, def off - 46

10 Scan resume method, Time operated, carrier operated, def time operated - 47

Group, Antenna tuner

11 Ant tuner function while Rx signals, def off - 52

Group, DSP

12 Time constant for the noise reduction function, 7.5Ms, 20Ms, def 20Ms - 38

Group TX

13 Tx filter band width for SSB or AM mode, 2.4Kh 2.0Kh, def 2.4 - 33

14 TX equaliser, off flat, HB high boost, FP formant pass, BB bass boost, C conventional - 33

15 Speech processor compression level, 0Db to 25Db in steps of 5Db, def 10 - 32

16 VOX gain, 0 min 9 max, def 4 - 31

17 Mic gain for FM mode, L low H high, def L - 22

18 Sub audible tone frequency for FM mode, def 88.5 - 25

19 Type of sub audible tone for FM mode, B burst C continuous - 25

Group, CW

20 - 26

Group, DRU

27 - 28

Group, Digital operation

29 - 34

Group, computer interface

35

Group, Data transfer

36 - 37

Group, TX

38 TX inhibit, def off - 33

39 Linear amplifier control relay, def off - 61

Group, transverter

40 enables/disables the 50Mhz 144 or 430 transverter function - 51

Group, PF

41 Programs the PF button, def 51 Voice 1 - 49

42 Programs Mic PF button, def 54 A/B button - 49

43 Programs Mic PF2 button, def 62 split button - 49

44 Programs Mic PF3 button, def 65 M/V button - 49

45 Programs Mic PF4 button, def 50 monitor - 49

Group, RX

46 IF filter band width, off, 1800, 500, 270, all in hertz, def off - 36

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download