Service Manual: ENGINE - 5.4L (3V) - F-150 & MARK LT IN-VEHICLE ...

Printer Friendly View

Page 1 of 20

Service Manual: ENGINE - 5.4L (3V) - F-150 & MARK LT

IN-VEHICLE SERVICING > VALVE COVER - RH

Material

2008 Ford Pickup 5.4L Eng F150

Item

Motorcraft Metal Surface Prep ZC-31

PAG Refrigerant Compressor Oil R-134a Systems YN-12-D

Silicone Gasket Remover ZC-30

Silicone Gasket and Sealant TA-30

Specification WSH-M1C231-B

WSE-M4G323-A4

... 4/15/2016

Printer Friendly View

Page 2 of 20

Fig 1: Exploded View Of Tube & Wiring Harness Retainer Connections With Torque Specifications

Courtesy of FORD MOTOR CO.

Item 1 2 3 4

5

Part Number N804758 19836 -

6758

Description

A/C compressor manifold tube assembly nut A/C compressor manifold tube assembly A/C compressor manifold tube O-ring seal Suction accumulator-to-A/C compressor manifold tube stud Crankcase vent tube assembly quick-connect fitting

... 4/15/2016

Printer Friendly View

Page 3 of 20

6

-

7

-

Engine wiring harness retainers (part of 12B637)

Variable camshaft timing (VCT) solenoid electrical connector (part of 12B637)

Fig 2: Exploded View Of RH Valve Cover & Gasket

Courtesy of FORD MOTOR CO.

Item 8 9

Part Number 6582 6584

Description RH valve cover RH valve cover gasket

IN-VEHICLE SERVICING > VALVE COVER - RH > REMOVAL

1. Recover the refrigerant. For additional information, refer to CLIMATE CONTROL SYSTEM - GENERAL INFORMATION AND DIAGNOSTICS article.

2. Remove the PCM and bracket. For additional information, refer to ELECTRONIC ENGINE CONTROLS article.

3. Remove the RH ignition coils. For additional information, refer to ENGINE IGNITION 5.4L (3V) article.

... 4/15/2016

Printer Friendly View

Page 4 of 20

4. Remove the nut and disconnect the A/C compressor manifold tube. 1. Discard the O-ring seals.

5. Remove the suction accumulator-to-A/C compressor manifold tube stud. 6. Disconnect the evaporator inlet tube fitting.

1. Discard the O-ring seals. Fig 1: Locating Evaporator Inlet Tube Fitting

Courtesy of FORD MOTOR CO.

7. Disconnect the quick connect couplings and remove the crankcase ventilation tube. For additional information, refer to FUEL SYSTEM - GENERAL INFORMATION article.

8. If equipped, disconnect the vacuum tube.

... 4/15/2016

Printer Friendly View

Fig 2: Vacuum Tube

Page 5 of 20

Courtesy of FORD MOTOR CO.

9. Disconnect the variable camshaft timing (VCT) solenoid electrical connector. 10. Detach the engine harness retainer and position the harness aside.

... 4/15/2016

 ................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download