Chapter 2 Answers to Review Questions - Saddleback College



Chapter 2 Answers to Review Questions

•Classroom Manual, Pages 41–42

Short Answer Essays

1. The primary purpose of the drivetrain is to connect and disconnect the engine’s power, to select different gear ratios, to provide a means of reversing the movement of the vehicle, and to supply power evenly to the wheels while the vehicle is making a turn.

2. Torque increases when a smaller gear drives a larger gear, because the distance from the center of the gear to the point where the gear teeth contact on the drive gear compared to the distance from the center of the driven gear and the point where the gear teeth contact is different. The torque will increase in proportion to the size difference of the drive gear compared to the driven gear. It is the basic principle of the lever.

3. Gear ratios are calculated by dividing the number of teeth on the driven gear by the number of teeth on the drive gear and are expressed as a ratio, drive:driven.

4. Transmissions are equipped with different forward gear ratios to allow for a changing amount of torque being delivered to the drive wheels and allows the engine to operate in its maximum torque curve. This increases the overall efficiency of the drivetrain.

5. The primary differences between a transaxle and a transmission are that a transaxle has all of the drivetrain parts housed in a single unit. A transmission is located on the rear of an engine and all other drivetrain components extend to the rear of the vehicle and power is supplied to the rear wheels.

6. A U-joint and CV joint allow the driveline to transmit power through the driveline in spite of the fact that the driveline angles are properly aligned and are constantly changing.

7. The differential receives torque from the transmission where it multiplies the torque in proportion to the gear ratio of the ring gear and pinion. It also transmits power around a corner to the rear wheels.

8. The purpose of a clutch is to provide a smooth engagement and disengagement of the engine’s power to the drivetrain. The clutch consists of a flywheel, pressure plate, and clutch disc. The clutch disc is connected to the transmission’s input shaft. The pressure plate applies pressure on the clutch disc that is sandwiched between the pressure plate and the flywheel, causing it to rotate with the flywheel.

9. The kinds of gears that are commonly found in automobiles are straight spur gears, helical gears, bevel gears, spiral bevel gears, and hypoid gears.

10. Ball- and roller-type bearings are used wherever friction must be minimized.

Fill-in-the-Blanks

1. Clutch, transmission, drive axles

2. Engine torque

3. Multiply

4. Distance, shaft

5. Foot-pounds, Newton-meters

6. Driven, drive

7. Third gear

8. Pressure plate, clutch disc

9. Transaxle

10. Drive shaft

Multiple Choice

1. C

2. C

3. A

4. C

5. B

6. C

7. B

8. B

9. C

10. A

•Shop Manual, Pages 60–61

ASE-Style Review Questions

1. A

2. C

3. B

4. C

5. C

6. C

7. C

8. C

9. C

10. D

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download