Physics 4A Lab 8: THe Simple Pendulum
Physics 40 Lab 6: The Simple Pendulum
In this experiment, your job is to test equations that describe the motion of a simple pendulum.
The pendulum shown has bob mass m, string length l (= R), and initial displacement angle given by (.
Applying Newton’s second law to the tangential and radial components of force we can derive equations of motion as a function of the displacement angle, where at is the tangential acceleration, v is the tangential velocity, and T is the tension in the string:
(1) (2)
An analysis of the oscillatory motion gives an equation for the period of oscillation, P (s):
(3)
Notice that the equation for the period of oscillation for a simple pendulum is independent of the mass of the bob and the angle of release. It only depends on the length of the string and the acceleration due to gravity. We will test to see if indeed this is validated by experimental data.
Definitions
Period of the Pendulum: the time measured in seconds for the pendulum bob to go from one extreme position to the other and back again: the time it takes to complete one cycle.
Amplitude: The size or angle of the arc the pendulum is displaced from equilibrium, for this lab measured in degrees.
Equipment
Lab Jack, Table clamp, Long Rod, Pendulum clamp, 3 pendulum balls – (wood, aluminum,& brass), Single pendulum string, Protractor, Lab Pro, Motion detector, force probe & cables
Procedure Set up the pendulum and probes as shown by your instructor. Open an Excel data sheet and the LoggerPro file in the Physics 40 Lab 6 Pendulum folder. You will need to open a word document for the analysis part of your group lab report.
Part I: Testing Equations (1), (2) and (3)
The first part is mostly a qualitative – we re not taking a lot of data or doing error analysis. You will explore the motion of a simple pendulum and test the equations to see if they are believable.
Set up the pendulum with the brass ball but first measure the mass of the brass bob and the length of the string and record these in your data sheet. Use the protractor to set the angle of release to something less than 15 degrees and collect data so that you get a smooth sinusoidal curve for the data plots. If there is ‘clipping’ (the bob and data curve disappears) reduce your release angle. Once you find a good angle to use, note it in your data sheet.
Set the bob in motion and collect both F vs t and x vs t data plots in Logger Pro. Copy and paste these into your report and do/answer the following (you can copy and paste these too!):
1. Describe the type of motion given by the graphs. Do equation (1) and (2) agree with the data plots? Find the values for the acceleration, velocity and the tension from the data plots at the release angle and at the bottom of the path? Note these in the data sheet. Calculate those values given by (1) and (2) (show the calculations – you can leave space and do them by hand) for the release angle and at the bottom of the path (you will have to use the velocity found from the data plot to use equation (2)). Do the values agree? What is the percent discrepancy?
2. Determine the period of oscillation from your graph by measuring the total time for 10 cycles and dividing by 10. Note this in your data sheet. Copy and paste the plot into your lab and show how you found the time for 10 cycles. Now calculate the value for the period using equation (3). Show the calculation and put the value in your data sheet. Do they agree? What is your percent discrepancy?
3. Briefly summarize your results.
Part II: The Period of a Simple Pendlum: Dependence on mass, length and amplitude
Effect of Mass
You will set up a pendulum with a 3 different bobs of different masses while keeping the string length and amplitude constant to find if mass affects the period of oscillation.
Effect of Mass
1. Weigh the bobs & string to get the total mass. Measure the length of the string. Set up your pendulum with the heaviest bob and determine a fixed angle (use the one from above.) Enter these values into your data table.
2. Use the motion detector to graph the periodic motion for as many cycles for which the data is good (about 10) and find the period for one cycle. Calculate the period using formula (3). Enter into these values into your spreadsheet. Repeat for the two other bobs, keeping the string length and amplitude constant.
3. Determine the % difference between the theory and experiment. Does the period change with changing mass?
Effect of Amplitude
1. Set up a pendulum with the heaviest bob keeping the string length and mass constant. Measure the period as above for at least 3 different angles, ranging between 10-40 degrees. Calculate the period for the pendulum using equation (3) for the three different angles. (opps – it doesn’t depend on the three angels!! ;-) Find the percent difference. Does the period change with changing mass?
Effect of Length
1. Set up a pendulum with the heaviest bob. Keeping the mass and amplitude constant, measure the period as above for at least 5 different string lengths. Be sure to take data three times and get an average period and an average deviation for each string length.
2. Using equation (1) and the values of your length, calculate the period for the pendulum and enter the value into the data table. Find the percent difference.
3. Graph your experimental data, Period (s) vs Length (degrees). Label your graph
You may have to change the maximum values on the axes.
4. Do a power-fit for the graph. What is the value of the exponent? What is the value of the coefficient? What is the R squared value? Does your graphical data and analysis support the theoretical equation (3)?
5. Determine a value of g from this coefficient and give a percent error from the accepted value of 9.80m/s2. How does this method compare to the other ones you have tried in this lab class?
Conclusion: What can you conclude about the effects of mass, length and amplitude on the period of a pendulum? Write a summary of your results.
-----------------------
[pic]
[pic]
[pic]
[pic]
[pic]
................
................
In order to avoid copyright disputes, this page is only a partial summary.
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.
Related download
- speed worksheet
- pendulum worksheet
- physics oak park independent
- wave worksheet home buckeye valley
- pre test physics questions and answers
- physics 11 formula sheet mr nguyen s website home
- physics 4a lab 8 the simple pendulum
- project1 automation using light sensors
- acceleration worksheet deer valley unified school district
Related searches
- find the simple interest
- find the simple interest rate
- the simple present tense pdf
- physics equilibrium lab report
- physics spring lab report
- the simple past tense worksheet
- uses of the simple future
- questions in the simple present
- the simple present tense
- the simple present
- the simple present tense ppt
- in the simple circular flow model