SS-100 Serial Server Installation and Programming Guide

026-1607 Rev 2 4-04-01

SS-100 Serial Server Installation and

Programming Guide

1640 Airport Road, Suite 104 Kennesaw, GA 31044 Phone: (770) 425-2724 Fax: (770) 425-9319

ALL RIGHTS RESERVED. The information contained in this manual has been carefully checked and is believed to be accurate. However, Computer Process Controls, Inc. assumes no responsibility for any inaccuracies that may be contained herein. In no event will Computer Process Controls, Inc. be liable for any direct, indirect, special, incidental, or consequential damages resulting from any defect or omission in this manual, even if advised of the possibility of such damages. In the interest of continued product development, Computer Process Controls, Inc. reserves the right to make improvements to this manual, and the products described herein, at any time without notice or obligation.

Table of Contents

1 INSTALLING THE SS-100 .......................................................................................................................................... 7

1.1. WORKING WITH THE NETWORK ADMINISTRATOR ....................................................................................................... 7 1.2. IP ADDRESS SPECIFICATION ......................................................................................................................................... 7 1.3. NETWORK CONSIDERATIONS ........................................................................................................................................ 7 1.4. ETHERNET NETWORK WIRING AND WIRE TYPES ........................................................................................................ 7

2 INSTALLING THE SS-100 FOR EINSTEIN CONTROLLERS ............................................................................. 8

2.1. CONFIGURING THE SS-100 FOR EINSTEIN CONTROLLERS............................................................................................ 8 2.2. SETTING UP FOR ALARM DIALOUT............................................................................................................................... 9 2.3. CONFIGURING ULTRASITE............................................................................................................................................ 9

3 CONFIGURING THE SS-100 FOR REFLECS CONTROLLERS........................................................................ 10

3.1. CONNECT THE SETUP COMPUTER OR TERMINAL TO THE SS-100 .............................................................................. 10 3.2. SET UP WINDOWS HYPERTERMINAL FOR A DIRECT CONNECTION TO THE SS-100................................................... 10 3.3. SET UP SS-100 FROM THE LOCAL_1> COMMAND PROMPT....................................................................................... 11 3.4. CONNECT SS-100 TO TCP/IP AND RS232 (COM C) NETWORKS ............................................................................. 11 3.5. INSTALL THE LANTRONIX COM PORT REDIRECTOR SOFTWARE ON REMOTE COMPUTER ........................................ 12 3.6. CONFIGURE THE LANTRONIX COM PORT REDIRECTOR ............................................................................................ 12 3.7. SET UP REDIRECTED COM PORT IN ULTRASITE ....................................................................................................... 12

SS-100 Serial Server

?v

 ................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download