PROLUX HOBBY CO



PROLUX ®

NO. 1833 Li-Polymer 1 ~2 Cell Charger

MAIN FEATURES：

1. Using the microprocessor-controlled technology optimizing your battery to do efficient and precise digital charge.

2. Automatically detect the 1 or 2 cells.

3. Selectable charge rate 500mA ~ 1000mA.

4. With LED light and beeper to indicate the charging status.

5. START/STOP switch.

6. Input has short circuit protection circuitry.

7. Output utilizes the PTC fuse for a completely safe charging experience.

HOW TO CHARGE：

1. Plug the charger into a DC 12V power source, that the charger will beep once and the LED flashes once as well.

2. Select the charge rate 500mA or 1000mA for charging your battery pack.

|Battery Capacity |Charge Rate |

|800mAH and below |500mA |

|800mAH and above |1000mA |

3. Plug the connector to the Li-Po battery pack and push the Start button. The beeper will sound once and the LED light will be on. The charger now began to charge.

4. Push one more Start button if you want to stop charge function during charging.

5. When charging is complete, the charger will beep ten times and the LED flashes slowly. The beeper will sound once every minute until the battery is disconnected.

PRECAUTIONS：

1. This charger is DC only, please note (+) (-) can not be connected inversely.

2. When voltage is below 10V, the charger will be no work.

3. This charger is lithium-ion battery charger. It CAN NOT charge Ni-Cd and Ni-MH battery pack, since their characteristics are totally different.

4. Maximum charging ratio of the Li-Po battery should not be over 1C.

5. Please check power source or output if they were connected inversely when the charger can not work.

6. The Li-Po battery will decrease the efficiency after overdischarging. Charge would be failed.

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download