Step 1: eWON Basic Setup - Amazon Web Services



Getting a PC internet access using a Bolt access point and an eWON deviceCreated By: Tim BeaulieuVersion 1.0Created on: 4/18/2019Last Updated: 4/29/2019Contents TOC \o "1-3" \h \z \u Step 1: eWON Basic Setup PAGEREF _Toc6492035 \h 2Step 2: Bolt Basic Setup PAGEREF _Toc6492036 \h 3Step 3: PC settings PAGEREF _Toc6492037 \h 4Step 1: eWON Basic SetupDownload eBuddy and connect a cable between your pc and port 1 of your cosy/flexy.Go onto eBuddy and change the LAN IP address to be in the 192.168.0.xxx range so that it’s in the same subnet as the wireless boltGet onto the eWON’s webpage by going onto eBuddy and right clicking on the device and then going to open in browser.Run through the Talk2M Wizard and make sure that you pass the internet wizard.Following the steps from the knowledge base article KB-0068-00, we will make some changes to the COMCFG file. These include:Hit the save button and reboot the device.Step 2: Bolt Basic SetupConnect to your Anybus Wireless Bolt and go to it’s webpage. (Default is 192.168.0.99)Go to Network Settings and set the Default Gateway to be the LAN IP address of the Cosy.In this example, the LAN address is going to be 192.168.0.28Next go onto the WLAN Settings and set the Bolt to be an Access Point. Then save and reboot.Step 3: PC settingsWhen the bolt is online connect to it’s wireless access point. In this case I just called mine Bolt and I’ll connect to that.Make sure that you set your default gateway to be the LAN ip address of the cosy. Also I’d recommend using the DNS settings shown in the picture above. ................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download