DRL (Daytime Running Lamp) ENABLE - Ram Trucks

Daytime Running Lamp Enable

08//2015

DRL (Daytime Running Lamp) ENABLE

Ram 2500 3500, 4500 and 5500 trucks not equipped with daytime running lamps (sales code LMK, LM1 or LM5) can have the feature enabled by the dealer. This service call will not be covered under warranty. Dealer charges may apply.

This is done by adding DRL as a dealer installed option and then reconfiguring the vehicle. There are several sales codes available for DRL depending upon head lamp type and market. The appropriate sales code should be added to the vehicle configuration as follows:

The dealer should add the DRL option to the vehicle using the VEHICLE OPTION UPDATES page in DEALERCONNECT. A link to the page can be found in the WARRANTY ADMINISTRATION pane under the SERVICE tab. Once the appropriate sales code has been added, the vehicle should be reconfigured using the RESTORE VEHICLE CONFIGURATION routine in WiTech. This routine can be found under the DIAGNOSTIC PROCEDURES tab. After the vehicle has been reconfigured, a hard reset of the BCM should be performed and all fault codes that may have been set during the process should be cleared.

DRL is not a selectable feature in the EVIC/Radio personalization menu but can be changed with WiTech in the CUSTOMER PROGRAMABLE FEATURE menu. DRL must be turned on the CUSTOMER PROGRAMABLE FEATURE menu in order to make DRL operate.

Please note that DRL's will only illuminate when the engine is running, the vehicle is in gear and the park brake is not set.

 ................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download