Asphalt - Gradus
-----------------------
1. Ensure that the substrate is sound, dry and free from contaminants.
2. Place the profile into position and set the top of the frame so it finishes flush with the top of the opposing floorcovering. (*See note below)
3. Mark the substrate through the predrilled holes. Drill the substrate using a 6mm drill bit. Insert plug to suit.
4. Apply a proprietary cartridge adhesive to the back of the profile and screw the profile to the floor.
5. All corners should be mitre cut.
6. Once installed apply smoothing compound to the required level.
* In areas where opposing floorcoverings are not installed, skim the profile to the correct height and level using a spirit level.
If any further information is required, please do not hesitate to contact Gradus Technical Services on (+44)1625 428922 or fax on (+44)1625 425226
Data Sheet: (sheet 1 of 1) 28/02/08
Accessories
Installation Guidelines
Gradus Accessories, Park Green, Macclesfield, Cheshire SK11 7LZ England UK Tel: 01625 428922 Fax: 01625 433949
UMFA12, 18 and 25 Aluminium Matwell Frames
................
................
In order to avoid copyright disputes, this page is only a partial summary.
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.
Related searches
- introduction to asphalt pavement course
- asphalt pavement repair
- asphalt pavement thickness design guide
- asphalt pavement association
- asphalt paving training courses
- national asphalt pavement association
- asphalt types a b c d
- types of asphalt grades
- national asphalt pavement association members
- asphalt certification courses
- asphalt driveway repair methods
- asphalt patching products