PRODUCT INFORMATION SHEET - Coatings



PRODUCT INFORMATION SHEET

PRODUCT: GUARDIAN GRAFFITI REMOVER FOR PLASTIC SURFACES

Product Code: GGRPSPI Issue Date: January 2015 Page 1 of 1

Description

An environmentally friendly, low odour, biodegradable, non flammable graffiti remover suitable for polycarbonate, vinyl, plexiglass, acrylic plastic and other delicate plastic surfaces.

Application

STEP 1 Ensure the surface to be cleaned and cleaning equipment are completely dry prior to application of remover.

STEP 2 Apply sufficient amount of remover to graffiti by brush , atomiser or saturated cloth and work into graffiti using a circular motion. Leave remover to work for 3-5 mins

STEP 3 Commence removal at base of graffiti and work on small areas at a time. Remove each section as you go with a sponge and water or damp cloth

STEP 4 Stubborn stains or old graffiti may require multiple applications.

STEP 5 Wipe the surface dry between applications.

Specification Sheets: Before application refer to the corresponding Material Safety Data Sheets GGRPSMSDS

Thinning :Do not thin Wash Up:Water Shelf Life: 18 months in closed containers

Safety Precautions

*Keep out of reach of children.

*Avoid contact with eyes, wear suitable eye protection.

*Avoid contact with skin, wear suitable glove protection.

*Avoid vapour (or) spray mist, ensure adequate ventilation.

*Do not smoke. Store in a safe, dry place away from direct heat or any source of ignition.

*Keep unwanted product in sealed containers for disposal via appropriate waste collection.

First Aid

*If poisoning occurs, contact a doctor or Poisons Information Centre.

*If swallowed, do not induce vomiting, give plenty of water and seek medical advise

*If skin contact occurs, remove contaminated clothing and wash skin thoroughly with soap and water.

*If overcome by fumes, move to fresh air and if condition persists seek medical advise.

*If in eyes, hold eyes open, flood with water for at least 15 minutes and seek medical advise.

The statements above are compiled from our field of production and according to the latest technological developments and application techniques. Since application and working are beyond our control, no liability of the producer can be derived from the contents of this information sheet. Guardian Protective Coatings Pty Ltd and associated group of companies shall not be responsible for any damage or injury resulting from abnormal use of the material, from any failure to adhere or observe the recommendations, or from any hazards inherent in the nature of the material. It is the users responsibility to evaluate the information contained herein and use this product safely and within the current laws and regulations.

Prodinfo..doc

MATERIAL SAFETY DATA SHEETS

PRODUCT: GUARDIAN GRAFFITI REMOVER FOR PLASTIC SURFACES

Product Code: GGRPSMSDS Issue Date: January 2015

Page No: 1 of 3

Worksafe Hazard Assessment: Hazardous According To Criteria Of Worksafe Australia

UN: Transport is not regulated CLASS: Combustible Class C1 (AS1940)

SUB RISK: None allocated HAZ CHEM CODE: None allocated

EPG: None allocated PACKAGING GROUP: None allocated

POISON SCHEDULE: Not scheduled

USES: Cleaner for the removal of graffiti.

PHYSICAL AND CHEMICAL PROPERTIES

APPEARANCE: Clear pale yellow liquid.

BOILING POINT: >150(C MELTING POINT: 1

SPECIFIC GRAVITY: 1.02g/lt SOLUBILITY (WATER): Emulsifiable

FLASH POINT: 64 (C EXPLOSION LIMITS: No data available

% VOLATILES: No data available pH: 7.5

INGREDIENTS CAS Number Proportion

Glycol ethers 34590-94-8 30-60%

Dioxolanone 108-32-7 30-60%

Surfactants 0-10%

HEALTH HAZARD INFORMATION

INGESTION:

Ingestion may cause irritation to the stomach, nausea and vomiting. If vomiting occurs after ingestion, small droplets of the liquid may enter the lungs (aspiration) with the risk of chemical pneumonia being induced.

EYE:

Irritating.

SKIN

Mildly irritating.

INHALATION:

Product has very low volatility and does not evaporate readily. However, if generated, vapours or spray mists are irritating to the eyes, nose, throat, mucous membrane, and respiratory tract and have anaesthetic properties. Inhalation may cause headache, nausea and dizziness.

MATERIAL SAFETY DATA SHEETS

PRODUCT: GUARDIAN GRAFFITI REMOVER FOR PLASTIC SURFACES

Product Code: GGRPSMSDS Issue Date: : January 2015 Page No: 2 of 3

CHRONIC

No information available at present. Use good personal hygiene practices. Wash hands before eating, drinking, smoking or using the toilet facilities. The primary route of exposure is inhalation, skin and eye contact.

The primary routes of entry into the body are inhalation and ingestion.

TOXICITY DATA

No data available

FIRST AID PROCEDURES

INGESTION

NEVER GIVE AN UNCONSCIOUS PERSON ANYTHING TO DRINK NOR ATTEMPT TO INDUCE VOMITING.

If person is conscious, rinse mouth out with water ensuring that mouth wash is not swallowed. Give about 250ml (2 glasses) of water to drink. DO NOT attempt to induce vomiting. Seek medical attention.

EYE

Hold eyelids open and rinse the eye continuously with a gentle stream of clean running water for at least fifteen minutes. Seek medical attention.

SKIN

Remove contaminated clothing and wash thoroughly with soap and water. Use water alone, if soap is unavailable. Apply a moisturising hand cream, if available. Seek medical attention if any soreness or inflammation of the skin persists or develops later. Launder affected clothing before re-use.

INHALATION

Remove to fresh air. Keep warm and at rest. If breathing is laboured, hold in a half upright position (this assists respiration). Apply artificial respiration if breathing has stopped. Seek medical attention.

PRECAUTIONS OF USE

ENGINEERING CONTROL

There are no special requirements for use outdoors or in well ventilated areas. If the product is used in poorly ventilated areas then fan forced air ventilation may be required.

PERSONAL PROTECTION

Safety glasses with side shields or safety goggles, PVC or natural rubber gloves and overalls. Respiratory protection is unlikely to be required for normal use but if using large amounts of the product or if using in a confined or poorly ventilated area then wear an organic vapour/particulate respirator complying with the requirements of AS/NZS 1715 and AS/NZS 1716.

N.B. TAKE THE LIMITS OF ABSORPTION CAPACITY INTO ACCOUNT. CHANGE FILTERS REGULARLY.

AIR PURIFYING RESPIRATORS DO NOT PROTECT AGAINST OXYGEN DEFICIENT ATMOSPHERES

MATERIAL SAFETY DATA SHEETS

PRODUCT: GUARDIAN GRAFFITI REMOVER FOR PLASTIC SURFACES

Product Code: GGRPSMSDS Issue Date: JANUARY 2015 Page No: 3 of 3

FLAMMABILITY

Combustible. If the product is heated, vapours can form flammable mixtures with air in poorly ventilated conditions. May evolve toxic fumes if heated strongly or burned. The product may react with strong oxidising agents such as liquid or powdered chlorine.

EXPOSURE STANDARD

No exposure standards have been established for this product.

SAFE HANDLING PROCEDURES

STORAGE TRANSPORT

Transport is not regulated. Store out of direct sunlight in a cool well ventilated area below 25(C. Higher temperatures may cause pressure build up inside containers. Segregate from oxidising agents and acids. Protect containers against physical damage.

RISK PHRASES PACK SIZE

R36: Irritating to Eyes 250 & 750ml Trigger Packs, 5lt & 20lt Plastic Containers

SPILLS DISPOSAL

SPILLS: Ensure that there are no sources of ignition present. Remove unnecessary personnel from the affected area. Wear protective equipment as specified for handling. If possible, dam the spill. Cover with an absorbent such as earth, sand or a commercial oil absorber. DO NOT use combustibles such as sawdust. Sweep up and collect. Dispose to approved land-fill or by controlled incineration.

DISPOSAL: If possible, return to supplier. Otherwise, dispose by controlled incineration or to approved land-fill.

FIRE EXPLOSION

Combustible. Containers may rupture if heated strongly. Wear self contained breathing apparatus. If possible remove containers from the vicinity of the fire. Otherwise keep containers as cool as possible by spraying with water, from a protected position. Water is not effective for fire fighting and direct contact with water should be avoided. Extinguish using foam, powder (bicarbonate or ammonium phosphate based) or carbon dioxide.

CONTACT POINT Emergency Advice 13 11 26 Poisons Information Center

Issue date: January 2015

Supersedes issue date: January 2004

Reason for issue: Company Details.

APPROVED BY : G J Dwyer

This data sheet and the health and safety hazard information it contains is considered to be accurate as at the date of issue. However, no warranty or recommendation, express or implied, is made as to the accuracy or completeness of the data and information contained within. Each user should read this data sheet and consider the information in the context of how the product will be handled and used. Health and safety precautions mentioned in this data sheet may not be accurate for all individuals and/or situations. Guardian Protective Coatings and associated group of companies shall not be responsible for any damage or injury resulting from abnormal use of the material, from any failure to adhere or observe the recommendations, or from any hazards inherent in the nature of the material. It is the users responsibility to evaluate the information contained herein and use this product safely and within the current laws and regulations.

msds.doc

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download