Merging Autopilot/Flight Control and Navigation-Flight Management Systems

[Pages:2]American J. of Engineering and Applied Sciences 3 (4): 629-630, 2010 ISSN 1941-7020 ? 2010 Science Publications

Merging Autopilot/Flight Control and Navigation-Flight Management Systems

Khaleel Qutbodin Department of Aerospace Engineering, Faculty of Mechanical Engineering,

International Islamic University of Malaysia, Malaysia

Abstract: In this abstract the following commercial aircraft 3 avionics systems will be merged together: (1) Autopilot Flight Director System (APFDS), (2) Flight Control System (FCS) and (3) Flight Management Systems (FMS). Problem statement: These systems perform functions that are dependant and related to each other, also they consists of similar hardware components. Each of these systems consists of at least one computer, control panel and displays that place on view the selection and aircraft response. They receive several similar sensor inputs, or outputs of one system are fed as input to the other system. By combining the three systems, repeated and related functions are reduced. Since these systems perform related functions, designers and programmers verify that conflict between these systems is not present. Combining the three systems will eliminate such possibility. Also used space, weight, wires and connections are decreased, consequently electrical consumption is reduced. To keep redundancy, the new system can be made of multiple channels. Approach: The new system (called Autopilot Navigation Management System, APNMS) is more efficient and resolves the above mention drawbacks. Results: The APFDS system functions (as attitude-hold or heading-hold) are merged with the FCS system main function which is controlling flight control surfaces as well as other functions as flight protection, Turn coordination and flight stability augmentation. Also the Flight Management system functions (as flight planning, aircraft flight performance/engine thrust management) are merged in the new system. All this is done through combining all 3 systems logic software's. Conclusion/Recommendations: The new APNMS system can be installed and tested on prototype aircraft in order to verify its benefits and fruits to the aviation industry.

Key words: Integrated avionics systems, Autopilot/Flight-Director system (A/P-F/D), Flight Control System (FCS), Flight Management System (FMS)

INTRODUCTION

command to the flight control surfaces. Similarly

existing FMS system feed commands to the APFD

Three aircraft avionics systems which study jointly together to fly the aircraft are the APFD, FCS and FMS systems. There functions are complementary to each other. The hardware of these systems is also similar to each other, each system has at least one computer and a controller/keypad by which function selection is made and display panels in the cockpit by which selected mode attitude is exhibited. In addition each as power supply, interface board, sensor input. Major manufacturers of the avionics systems are endeavoring to combine the avionics subsystems as much as possible (Ramsey, 2007).

system which in turn feed it to the FCS system; again this requires processing and controlling from both systems and partial processing from both systems.

The merging these 3 systems together is performed according to the phase of the flight (which is done according to altitude of the aircraft, as Take-off, Goaround, climb, cruise, descent, approach and AutoLand). The merged system is a software merge combining all 3 systems functions. The hardware diminished too simply to one computer system and save space, electrical load and weight (Watkins and Walter, 2007).

APFD system take commands from flight crew and aircraft sensors and process them to determine aircraft

MATERIALS AND METHODS

attitude then feed these commands to the FCS system

Material used is (C+) language; however any

through interface circuitry/logic. The FCS system also Software language can be used.

requires inputs from sensors or other systems and from

Logics of the 3 systems (APFD, FCS and FMS) are

APFD/FMS systems, it then processes them to output merged together.

629

Am. J. Engg. & Applied Sci., 3 (4): 629-630, 2010

RESULTSAND DISCUSSION

REFERENCES

Flow-chart and Program has been made and is validated against logics and laws of the aircraft Autopilot, flight control systems and also against the databases of the FMS system. No conflict is found.

CONCLUSION

Merging the 3 systems APFDS, FCS and FMS is possible and fruitful to the aviation industry.

ACKNOWLEDGMENT

Ramsey, J.W., 2007. Integrated modular avionics: Less

is

more.

Avionics

Magazine.



ercial/8420.html

Watkins, C.B. and R. Walter, 2007. Transitioning from

federated avionics architectures to integrated

modular avionics. Proceeding of the IEEE/AIAA

26th Digital Avionics Systems Conference, Oct.

21-25, IEEE Xplore Press, Dallas, TX., pp: 1-10.

DOI: 10.1109/DASC.2007.4391842

Financial and academic support is given by International Islamic University of Malaysia (IIUM), Industrial link to Saudi Aerospace and Engineering Industries.

630

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download