CHEMISTRY LAB: ISOTOPES AND ATOMIC MASS
Names: _________________________ _________________________ _________________________
Date: ________ Period: ____
Lab: Beanium (Bn)
(Isotopes and Average Atomic Mass)
Introduction:
The average atomic mass of an element is the weighted average of the masses of the isotopes of that element. The weighted average takes into account both the mass and relative abundance of each isotope as it occurs in nature.
Purpose:
In this lab you will determine the average atomic mass of the fictitious element beaniuim, Bn, from a mixture of three naturally occurring isotopes with different masses.
You will calculate the weighted average atomic mass, which is “weighted” by the different natural abundances (%’s) of each isotope.
Equipment and Materials Needed:
triple-beam balance
a sample of vegium in a plastic cup
two additional empty plastic cups
one or two stiff cards (for handling vegium)
Procedure:
1) Sort the isotopes of vegium into separate piles and count the “particles” of each isotope in your sample. Record the number of particles of each type in the Data Table.
2) Weigh an empty cup on the balance and record its mass.
Place all of one isotope in the cup and reweigh it. Record that mass also.
Subtract to find the mass of just the isotope.
3) Using the other two cups, repeat the process for the other two isotopes and record your results. Be careful: all similar-looking cups do NOT have the same mass.
4) When you are sure you have gathered all the required data, mix the three isotopes together again and return them. Return the empty cups to the prep area for reuse.
Check to make sure that no “isotopes” ended up in the sink or on the floor.
5) Complete the Calculations table to determine the Average Atomic Mass of vegium.
DATA TABLE
|Color of isotope: | | | |Total: |
| |____________ |____________ |____________ | |
|Mass (g): | | | | |
|# of particles: | | | | |
Calculations: (Use the Data Table on page 1 to complete the calculations for the table below)
CALCULATIONS TABLE
|Color of isotope: | | | |Overall: |
| |____________ |____________ |____________ | |
|Average | | | | |
|Mass (g): | | | | |
|% | | | |= 100 % |
|Abundance: | | | | |
Calculations: (Follow these instructions CAREFULLY to complete the calculations for the table above)
a. From the Data Table on the previous page, divide the mass by the # of particles to find the average mass of the each isotope.
To get the Overall average, Do NOT add the averages, divide the Total mass by the Total # of particles.
b. From the Data Table on the previous page, divide the # of particles by the Total # of particles and multiply by 100 to get the % relative abundance of each isotope.
c. Calculate the weighted Average Atomic Mass of beanium from its 3 isotopes using the following formula:
d.
Avg. At. Mass = (%)(Mass1) + (%)(Mass2) + (%)(Mass3)
(Note: the %’s must be in decimal form, that is, 78.5% must be 0.785 or 2.2% must be 0.022)
SHOW YOUR WORK:
Record your answer:
Questions:
1) If you compared your answers with those of another lab group and found a difference, how would you explain that, assuming neither group made a “mistake?”
_____________________________________________________________________
_____________________________________________________________________
2) If each group did the lab again using a larger sample, would you expect the differences that time to be larger or smaller than the first time? Why?
_____________________________________________________________________
_____________________________________________________________________
3) Why isn’t the atomic mass of each element a whole number?
(like Neon: 10 protons + 10 neutrons = 20 atomic mass of neon)
_______________________________________________________________________
_______________________________________________________________________
4) The “mass number” of “an atom” is not on the periodic table because the periodic table lists the _________________________________ of each element. Explain.
_______________________________________________________________________
_______________________________________________________________________
Conclusion: Write a paragraph discussing the lab’s purpose (on the first page)
and what you observed and learned about the average atomic mass of elements.
-----------------------
____ / 50
g
................
................
In order to avoid copyright disputes, this page is only a partial summary.
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.
Related download
- livingston public schools
- average atomic mass worksheet hubbard s chemistry
- chemistry lab isotopes and atomic mass
- name date
- study guide atomic srtucture classification of
- chemistry midterm exam review
- calculating average atomic mass worksheet name
- skill practice 9 st francis preparatory school
- mr kelleci s science class
Related searches
- atomic mass to mole calculator
- atomic mass calculator
- mass number and atomic number
- periodic table atomic mass number
- periodic table with atomic mass pdf
- atomic mass table of elements
- atomic mass chart
- atomic mass of all elements
- atomic mass unit chart
- atomic mass of elements list
- average atomic mass answer key
- calculating average atomic mass worksheet