CTEC History and Overview



|COMPANY |      |CONTACT |      |

|ADDRESS |      |PART OR DRAWING NUMBER |      |

| |      |ESTIMATED ANNUAL USAGE |      |

|PHONE |      |FAX |      |E-MAIL |      |

Application

| a. Customer application |      |

| b. What mechanism is the motor driving in the application? |      |

| c. ( New / Existing ) If existing, who is the current supplier? |      |Is unit available for test?| ( Yes No ) |

| d. Are there any problems or concerns with the existing supplier’s motor? |      |

Performance Requirements:

| |a. Rated Voltage |      |b. Voltage Range: |      |

| c. Output torque est. by |Select one |d. Start Torque |      |Select one |e. Run Torque |      |Select one |

| |f. RPM at No Load |      |g. RPM at Load |      |h. Will gearmotor be stalled? |Yes No |

Environment

| a. Ambient temp. |      |b. Humidity level |      |c. Degree of Protection(IP) |      |

| d. Heatsinking? |      |e. Thermal resistance of heatsink |      |f. Autoclavable? |      |

| g. Anything else we should know about the location of our motor within the application? |      |

| Duty Cycle/Life |( < 25% 25% 50% 75% Continuous Other ) |Define other |      |

| a. Standard duty cycle |      |ON Select one |      |OFF Select one |

| b. Most demanding |      |ON Select one |      |OFF Select one |

| c. Minimum life required |      | in cycles |      | in hours |note: both required |

Power Supply

| a. Rated voltage: |      |b. Maximum current limit |      |c. Is the supply filtered? |( Yes No ) |

| d. Supply type: |( Switched Mode Transformer, bridge, cap, linear regulator battery ) |Frequency: |      |kHz |

|Overhung Load ( Yes No ) |How much? |      |lbs. |Distance from mounting surface |      |

|Axial Thrust Load ( Yes No ) |How much? |      |lbs. |( Push-in Pull-Out Both ) |

Output Shaft Requirements

| a. Shaft OD |      |b. Direction of rotation |( CW CCW ) |Viewed from |Cover Side |Motor side |

| c. Shaft Detail |Flat |Tongue |Woodruff Key |Hole |Keyway |Slot |

| d. Extension from mounting surface |Cover Side |      |Motor Side |      |

| |If other, please list: | |

|Agency Requirements: UL CSA CE RoHS Other | | |

| |      |Method of test |      |

|Sound / Vibration Requirements | | | |

| |      |

|Gear Box Selection Select ratio from catalog list | |

EMI / RFI Considerations Emissions Type: ( Conducted Radiated Both )

| |If other, please list: | |

|Agency Requirements: UL CSA CE RoHS Other | | |

Feedback Requirements: Yes No

| Encoder Hall Effect Optical |Channels 1 2 |Line Driver |Index Pulse       |PPR      |

Motor Driver Requirements

|Motor driver (amplifier required) |Type of Motor Speed Control Select one |c. Closed Loop Select one |

|( Yes No ) | | |

|d. Is reverse direction required? |e. Is integral electronics required? |f. Special Control Requirements |

|( Yes No ) |( Yes No ) |( Braking Soft Start Current Limit ) |

Mounting Position: Indicate orientation in your application as shown below: Select one

[pic][pic]

Send this in via email to sabramson@:

[pic]

-----------------------

[pic] [pic]

BLDC SPECIFICATION SHEET

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download