JOB SAFETY ANALYSIS



|JOB SAFETY ANALYSIS |

| |

|Job: Loading trailers/mowers to trucks Date Completed: New:  Revised:  |

| |

|Department: Completed By: JSA #: |

| |

|Location: Reviewed By: |

|Required Personal Protective Equipment (PPE): Gloves, steel toe boots, orange vests |

|Basic Job Steps: |Potential Hazards: |Correct Procedures: |

| |Get hit by trailer, truck (SB, CI, SA, CBT) |Communication with co-workers on where and what you are doing. Review communications signals.|

|Pre-start check | | |

|Backing truck up to trailer and guiding truck to | |Stay out of the operators way |

|trailer | | |

| | |Check areas before you start backing and have spotter stay in one spot. |

| |Tripping and falling over equipment (FS) |Wear gloves |

|Hooking and securing trailer and connecting | | |

|lights |Strains from lifting (O) |Use proper lifting techniques or two people when necessary |

| | | |

| |Getting pinched by equipment(CI) |Be aware of surrounding |

| | | |

| |Shocked on electrical (E) | |

|Lower ramps to vehicle |Getting struck by ramps (SB) |Be aware of surroundings |

| | | |

| |Tripping and falling over equipment (FS) | |

| | | |

| |Cuts for equipment (CW) |Wear gloves and steel toe boots |

| | | |

| |Strains from lifting (O) |Use proper lifting techniques or two people when necessary |

|Starting mower (pre-start check) |Burns from equipment |Be aware of surroundings |

| | | |

|**See JSA about mounting and starting mower |Falling off equipment (FS) |Use the three-point contact system when climbing onto equipment |

|Backing mower onto trailer |Struck by trailer equipment(SB) |Communication with co-workers on where and what you are doing. Review communications signals.|

| | |Stay out of the operators way |

| |Caught by equipment (CB) |Check areas before you start backing and have spotter stay in one spot. |

| | |Wear seatbelt |

| |Rollover |Make sure roll over protections are on trailers |

|Secure mower and rest equipment |Getting pinched by equipment(CI) |Be aware of surroundings |

| | |Make sure area is clean and free from tripping hazards (good housekeeping) |

| |Tripping and falling over equipment (FS) |Use proper techniques (body mechanics) when securing equipment |

| | |Help with a cheater bar |

| |Strains from reaching (O) | |

|Lift Ramps and Secure them to vehicle |Getting struck by ramps (SB) |Wear gloves and steel toe boots |

| | |Be aware of surrounding |

| |Tripping and falling over equipment (FS) |Use proper lifting techniques or two people when necessary |

| | | |

| |Cuts for equipment | |

| | | |

| |Strains from lifting (O) | |

|Final Inspections |Tripping and falling over equipment (FS) |Be aware of surrounding |

Employee Signature:_______________________________________ Date:_____________________

*Codes for Potential Hazards:

|Struck By (SB) | |Caught On (CO) | |Fall To Below (FB) |

|Struck Against (SA) | |Caught In (CI) | |Overexertion (O) |

|Contacted By (CB) | |Caught Between (CBT) | |Exposure (E) |

|Contact With (CW) | |Fall - Same Level (FS) | | |

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download