The Instruction of Spy DVR Watch



Spy DVR Watch

Instructions

Thank you for purchasing the Spy DVR Watch.

Before using, please read these instructions carefully.

Features

Working analogue watch with sweep second hand.

Hidden video camera and built-in microphone.

Built-in DVR (Digital Video Recorder).

Memory：1GB/2GB/4GB/8GB (optional)

Can be used as USB Flash drive.

Video format : AVI : 640 x 480 : 300,000 pixels.

Video recordings are time-stamped with date and time.

Rechargeable Lithium battery for up to 2 hours recording time.

Automatic shut down to save batteries if left in standby mode.

No drivers required for 2000/ XP/ Mac OS 9.2.2 or above.

Driver disk enclosed for Win 98.

Charge by USB connection to PC or use supplied mains charger.

1. Once connected correctly, the blue LED will illuminate.

2. When blue light is off and the amber light is on, the battery is fully charged.

3. If the battery runs low, the DVR will power down and automatically store the video in memory.

Appearance & buttons

[pic]

1. Start/ Stop Video recording.

2. Reset

3. USB port

4. LED light

5. Time adjustment

6. Camera

7. Mic

Operation

1. To Start Recording.

Press button 1 for 2 seconds. Orange LED will illuminate briefly and then go out. Recording starts.

2. To Stop Recording.

Press button 1 for 2 seconds. Blue light will illuminate briefly and recording stops.

3. Reset

If the unit is non responsive or you can’t remember which mode its in, press button 2.

4. Driver Installation

Needed for Windows98 only.

Insert the driver CD into your computer.

Browse to the USB_Driver folder and right click on the M3usb.inf file and click INSTALL. After a reboot, the driver should install automatically.

PC Connection

1. Insert the USB cable into the USB port (3) on the watch. Remove dust cap first.

2. Connect the other end to a USB port on your PC.

3. It should be detected as a removable drive containing a folder called VideoRecord.

To Disconnect the USB device.

a. Right-click the “Safely Remove Hardware” icon in the notification area (near the clock). Click “Safely Remove Hardware”

b. A dialog box should now indicate “It Is Safe To Remove Hardware”.

c. Close the dialog box.

d. Disconnect the watch from the PC.

To Set Up the Time Stamp Feature

1. Connect the watch to your PC via the USB cable.

2. Browse to the folder marked VideoRecord.

3. Inside this folder create a file called TimeStamp.txt

4. The Date and Time should be entered as shown:-

2009-21-08 21:56:30

[pic]5. Save the SystemTime.txt and “safely remove” the device.

The recording will now have this time stamped on the image.

Trouble-shooting

|Can not turn on |Check if the battery is discharged. |

|Cannot download and |Check if the USB cable between the watch and the PC is in good condition and connected |

|Upload files normally |correctly. |

| |Check if the drivers are installed (Win98) |

| |Check if the watch has enough space to store video files. |

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download