Introduction - Serious game



Author Guidelines for 8.5 x 11-inch Journal ArticleAuthor Name1, Author Name2, Author Name3, Author Name41Author Affiliation, E-mail{carlo.rossitto, peter.fox, robert.schwarz}@university.edu2 Affiliation, E-mail3,4 Affiliation, E-mailAbstract The abstract is to be in fully-justified italicized text as it is here, below the author information. Use the word “Abstract” as the title, in 14-point Times New Roman, boldface type, on the left after 0.5cm, initially capitalized. The abstract is to be in 11-point, single-spaced type, and may be up to 3 in. (18 picas or 7.62 cm) long, italicized. Leave two blank lines after the abstract, then begin the main text. All manuscripts must be in English. All text material for 8.5 x 11-inch journal article will be formatted in a single column per page.Keywords: Keyword1, Keyword2, Keyword3;Introduction Congratulations! Your paper has been accepted for journal publication. Please follow the steps outlined below when submitting your final draft. These guidelines include complete descriptions of the fonts, spacing, and related information for producing your journal manuscripts.Citation should be worked form references in part of introduction and related words, and should be followed the format of the citation of the journal.For example, AR has actually been applied to education for students in classrooms recently, with its educational effect validated as well [1][2]. AR has also been tried in the area of educating of younger children through AR book [3-5] or …. References must be numbered in order of appearance [6].Formatting your paperAll printed material, including text, illustrations, and charts, must be kept within the parameters of the 8 15/16-inch (53.75 picas) column length and 5 15/16-inch (36 picas) column width. Please do not write or print outside of the column parameters. Margins are 1 5/16 of an inch on the sides (8 picas), 7/8 of an inch on the top (5.5 picas), and 1 3/16 of an inch on the bottom (7 picas). Next paragraph.Typical issues in final paper formattingPlease check that references are numbered in order of appearance; all the fonts; every image/table and its caption should be on the same page; tables should preferably not be split across pages; indentation should starts from the second paragraph of each (sub)section; references in IEEE syle: ; odd pages apart from the first one should report in the header authors and title. Size reductions are applicable when needed, as the header must stay on one line.. Main titleThe main title (on the first page) should begin 1 3/16 inches (7 picas) from the top edge of the page, centered, and in Times New Roman 14-point, boldface type. Capitalize the first letter of nouns, pronouns, verbs, adjectives, and adverbs; do not capitalize articles, coordinate conjunctions, or prepositions (unless the title begins with such a word).Please initially capitalize only the first word in other titles, including section titles and first, second, and third-order headings (for example, “Titles and headings” — as in these guidelines). Leave a row and one blank lines after the title and two blank lines before the title. Author name(s) and affiliation(s)Author names and affiliations are to be centered beneath the title and printed in Times New Roman 12-point, non-boldface type. Multiple authors may be shown in a two or three-column format, with their affiliations below their respective names. Affiliations are centered below each author name, italicized, not bold. Include e-mail addresses if possible. Follow the author information by one blank lines before main text. Second and following pagesThe second and following pages should begin 1.0 inch (2.54 cm) from the top edge. On all pages, the bottom margin should be 1-3/16 inches (2.86 cm) from the bottom edge of the page for 8.5 x 11-inch paper; for A4 paper, approximately 1-5/8 inches (4.13 cm) from the bottom edge of the page. Type-style and fontsWherever Times New Roman is specified, Times Roman, or Times may be used. If neither is available on your word processor, please use the font closest in appearance to Times New Roman that you have access to. Please avoid using bit-mapped fonts if possible. True-Type 1 fonts are preferred. Main textType your main text in 11-point Times New Roman, single-spaced with 11-point interline spacing. Do not use double-spacing. Be sure your text is fully justified—that is, flush left and flush right. Please do not place any additional blank lines between paragraphs.Figure and table captions should be 11-point Times New Roman (or a similar sans-serif font), italics. Callouts should be 10-point Times New Roman, non-boldface. Initially capitalize only the first word of each figure caption and table title. Figures and tables must be numbered separately. For example: “Figure 1. Database contexts”, “Table 1. Input data”. Figure captions are to be below the figures. Table titles are to be centered above the table. Class Diagram for Caching Simulator using FIFO, LRU and LRU with related contentProject selection matrix rules.if Project strength isAnd Project attractiveness isThen the project rank isLowLowLowLowMediumLowLowHighMediumMediumLowLowMediumMediumMediumMediumHighHighHighLowMediumHighMediumHighHighHighHighFirst-order headings For example, “1. Introduction”, should be Times New Roman 14-point boldface, text color is RGB = 23, 54, 93 (dark blue), initially capitalized, italicized, flush left, with one blank line before, one continuous border (as text color) at the bottom, ? pt thin and one blank line after. Next paragraph should be indented.Second-order headingsAs in this heading, they should be Times New Roman 12-point not boldface, italicized, initially capitalized, flush left, with one blank line before, and one after.Third-order headingsThird-order headings, as in this paragraph, are discouraged. However, if you must use them, use 11-point Times New Roman, not boldface, italicized, initially capitalized, flush left, preceded by one blank line, followed by a colon and your text on the same line. FootnotesAuthors cite the references of other papers during paper submission.If the cited references don't have exact information as below(especially, material's name, published year, issue and page no),there can be a problem of un-citable references when indexed on citation institute. Therefore, we strictly urge you to check the references carefully and indicate the exact information for them on your paper.List and number all bibliographical references in 10-point Times New Roman, single-spaced, at the end of your paper. For example, [1] is for a journal paper, [2] is for a document online, [3] is for a book, [4] is for a conference (symposium) paper. ReferencesIEEE syle: . Kaczorek,?"Minimum energy control of fractional positive electrical circuits",?Archives of Electrical Engineering, vol. 65, no. 2, pp.191–201, 2016.F. Vaskuri, H. Baumgartner, P. K?rh?, G. Andor, and E. Ikonen, "Modeling the spectral shape of InGaAlP-based red light-emitting diodes,"?Journal of Applied Physics, vol. 118, no. 20, pp. 203103-1–203103-7, Jul. 2015. Accessed on: Feb. 9, 2017. [Online]. M. Patrick,?"The origins of today's industrial robots, and where they're headed next,"?Electronics World, vol. 124, no. 1987, pp.19–19, Oct. 2018D. T. Hoang, D. Niyato, D. N. Nguyen, E. Dutkiewicz, P. Wang, and Z. Han, "A dynamic edge caching framework for mobile 5G networks,"?IEEE Wireless Communic., vol. 25, no. 5, pp. 95–103, Aug. 2018. Accessed on: Nov. 26, 2018. [Online].R. E.?Ziemer?and W. H.?Tranter,?Principles of Communications: Systems, Modulation,?and Noise,?7th ed. Hoboken, NJ: Wiley, 2015,?pp. 13–17.N. B. Vargafik, J. A. Wiebelt, and J. F. Malloy, "Radiative transfer," in?Convective Heat. Melbourne: Engineering Education Australia, 2011, ch. 9, pp. 379–398.?H. C. Hottel and R. Siegel, "Film condensation," in?Handbook of Heat Transfer,?2nd ed.?W. C. McAdams, Ed. New York: McGraw-Hill, 2011, ch. 9, pp. 78–99.K. Jegathala Krishnan, "Implementation of renewable energy to reduce carbon consumption and fuel cell as a back-up power for national broadband network (NBN) in Australia,"?Ph.D dissertation, College?of Eng. and Sc., Victoria Univ., Melbourne, 2013. Accessed on: June?16, 2017. [Online]. Available:?. O. Williams, “Acoustic analysis of sound,” B.S. Thesis, Sch. of Eng. and?Appl. Sciences.,?Harvard?Univ., Cambridge,?MA, 2013.D. Holland,?Finding the Building Blocks of Wood, The University of Melbourne, June 6, 2018. Accessed on: June?13, 2018. [Online]. Available:?'s Pocket Manual,?2nd ed.?Wiley Pub.,?Indianapolis, IN, 2003.?S. r. Ayyubi, Y. Miao, and H. Shi, "Automating standalone smoke alarms for early remote notifications," in?13th Intern. Conf.?on Cont.?Automa.?Robotics & Vision?(ICARCV), Marina Bay Sands Singapore, Dec. 2014, pp. 675–680.W. M.?Brown, A.?Semin, M.?Hebenstreit, S.?Khvostov, K. Raman, and S. J. Plimpton,?"Increasing molecular dynamics simulation rates with an 8-fold increase in electrical power efficiency," in?SC '16 Proc. of the Int.?Conf.?for High Perf.?Computing, Networking, Storage and Analysis,?Article?No. 8, Salt Lake City, Utah, IEEE Press Piscataway, November 13 - 18, 2016.?Accessed on Feb. 10, 2017.?[Online].? ................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download