Energy Questions - WCS Automotive Mechanics



Safety Questions Name ______________________________ X200

You will need the “Auto Fundamentals” text book and locate the chapter titled Safety, Lab Procedures.

Your teacher will take you through a walk-about of the shop explaining some procedures and safety concerns specific to this shop. You may or may not take this sheet with you on the tour, but you will need to pay attention to what is being explained.

After the tour, answer the following questions on this and the following pages.

1. Draw a small circle “o” around the each of the 4 points where a typical car should be lifted using a two post hoist, and draw a small square “ٱ” around the area where the front of the car should be lifted using a floor jack.

[pic]

2. Why should the doors be closed on a vehicle while lifting it on a hoist?

3. What did your teacher say about by doing this, may cause you to be extremely flammable or cause death if used carelessly?

4. List 4 methods used to avoid a vehicle fall while using a hoist in the shop.

■

■

■

■

5. List 2 methods used to avoid injury when lifting a vehicle with a floor jack.

■

■

6. Why should you lower an engine close to the floor while transporting the engine & crane?

7. List 2 methods used to avoid injury when working with hot cooling systems.

■

■

8. List 2 methods of avoiding a fuel fire or other fire.

■

■

9. Describe the location of all of the fire extinguishers in the auto shop.

■

■

■

■

10. What is the correct procedure to follow if you spill oil in the shop?

11. What situation could lead you to deal with pressurized fuel in the shop?

12. List 2 types of hazards that you could encounter while using compressed air.

■

■

13. When Boosting a dead battery,when should battery charger clamps be connected and disconnected from the battery?

14. Where are the following items stored until they are properly disposed of?

a. Waste oil (from an oil change) –

b. Used plastic containers –

c. Used oil filters –

15. Why is it necessary to wear a welding mask when using the MIG welder?

16. List 8 situations in the shop that require the use of safety goggles.

■

■

■

■

■

■

■

■

17. What is dangerous about using the strut spring compressor?

18. List 2 ways to avoid being hit by a car in the shop.

■

■

19. List 3 ways that driving a vehicle after it has been serviced can be dangerous, and provide one way of avoiding injury in each case.

■

■

■

20. How can you avoid carbon monoxide poisoning in the shop?

21. What is the expectation and consequence of not doing as expected in the following situations?

a. Leaving the shop during class time without permission

b. Parking outside of the shop or in the staff parking?

c. Horseplay – pushing or play fighting with others, throwing things, running?

d. Dangerous driving in the shop or parking lot – excessive speed, squealing tires etc.?

CHECKPOINT ____________1.0HR

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download