Plug-In AwareGPS Tracking Device Installation Guide

Plug-In AwareGPS Tracking Device Installation Guide

1. Locate the OBDII Port in Your Vehicle and Connect Your Device.

The connector is located under the dash and is required to be within two feet of the steering wheel. If you cannot locate the OBD connector, please reference your vehicle's owner manual.

When removing the device from your vehicle, make sure you grasp the

device as close to the port as possible.

2. Start Your Vehicle, and Check the Lights on the Device

The first time you plug-in the device, you will need to start your car in

order for the GPS tracking to start and for your vehicle to show up in the

Web site. Your vehicle must be outside and not in a covered area so that it will

receive GPS signal. When working properly, the blue light will blink once every 3

seconds and you will see a blinking green light. It may take up to

two hours to see your car's location on the map. You may use the

OCG

enclosed zip tie to secure the device and prevent tampering.

OBD (Orange) Cell (Blue) GPS (Green)

Off Blinking Blinking 1x/second Blinking 1x/3seconds Off Solid Blinking

Ignition's Off Ignition's On Searching for GSM Network GSM Lock (connected to network) Modem Reboot Searching for Satellite GPS Lock

IMPORTANT NOTICE: remove device before jump starting the vehicle.

Questions? Contact AwareGPS Customer Support: Phone: 1-855-894-8729

Email: support@

 ................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download