Lab 1: Maps I: A Visualization Tool – Worksheet



|Name: | | |Lab Section: | | |Date: | |

1. Figure 1 is a cross section of a subduction zone. We will use it to investigate the factors that determine the width of the arc-trench gap and formulate a scientific model relating these dips and the arc-trench gap. This model can be used to predict plate dip based on the size of the arc-trench gap.

a. Draw a line, representing the top of the subducting plate, from the trench to each subduction angle shown on the bottom and right-hand side of the diagram.

b. The volcanic arc is 100 km above the subducting plate. Project the position of each volcanic arc to the Earth’s surface. Mark the position with a V and a subscript indicating the dip angle—e.g., V10 for the slab dipping 10(.

c. Mark the earthquake pattern along each plate by showing shallow earthquakes (0 to 100 km) with an S, intermediate ones (100 to 200 km) with an I, and deep earthquakes (>200 km) with a D.

[pic]

Fig. 1

2. Using the following directions, transfer the location of the volcanic arc and earthquake distribution to the ocean floor maps in Fig. 2.

a. Measure the horizontal distance from the trench to the volcanic line. At the same distance from the trench, draw a line of circles to show the location of the volcanoes in the arc.

b. Measure the horizontal distance to the intermediate/deep earthquake boundary. At the same distance from the trench on the map, draw a dashed vertical line.

c. Indicate the distribution of each type of earthquake by drawing an arrow across the appropriate zone and labeling it with an S, I, or D.

[pic]

Fig. 2

3. The map views clearly show how the angle of the subducting plate determines the width of the arc-trench gap. Using the information you entered on the maps, it is possible to construct a scientific model that can predict the structure of subduction zones when you do not know the subsurface structure.

a. Measure the width of the arc-trench gap for each subduction angle and enter your measurements in Table 1.

b. Plot the width of the arc-trench gap versus the subduction angle on Fig. 3.

c. Draw a smooth curve through the data points.

d. From this plot, estimate the dip of the subducting plate if the arc-trench gap is 175 km.

e. For a trench gap of 175 km, and using the dip you determined in part d, estimate the farthest extent of

|(1) Shallow earthquakes: | |

| | |

|(2) Intermediate | |

|earthquakes: | |

|Table 1 | |

|Case | |Subduction zone dip | |Arc-trench gap (km) |[pic] |

| | | | | |Fig. 3 |

|1 | |10( | | | |

|2 | |20( | | | |

|3 | |30( | | | |

|4 | |40( | | | |

|5 | |50( | | | |

|6 | |60( | | | |

|7 | |70( | | | |

| | | | | | |

4. How does the dip of the subduction zone influence the arc-trench gap?

5. Where are most subduction zones located globally?

6. Why is this distribution so important in terms of geologic hazard planning?

7. What two geologic hazards are directly associated with subduction zones?

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download