SAFETY DATA SHEET ZEP INSTANT HAND SANITIZER GEL
SAFETY DATA SHEET
ZEP INSTANT HAND SANITIZER GEL
Version 2.10
Revision Date 07/09/2020
Print Date 10/26/2020
SECTION 1. PRODUCT AND COMPANY IDENTIFICATION
Material name
:
ZEP INSTANT HAND SANITIZER GEL
FDA ID Number:
Material number
66949-878-01
:
000000000000087801
Manufacturer or supplier's details
Company
:
Zep Inc.
Address
:
350 Joe Frank Harris Parkway, SE
Emerson, GA 30137
Telephone
:
404-352-1680
Emergency telephone numbers
For SDS Information
For a Medical Emergency
For a Transportation
Emergency
:
:
:
Compliance Services 1-877-428-9937
877-541-2016 Toll Free - All Calls Recorded
CHEMTREC: 800-424-9300 - All Calls Recorded.
In the District of Columbia 202-483-7616
Recommended use of the chemical and restrictions on use
This product is labeled as an over-the-counter (non-prescription) drug under the Food and Drug
administration (FDA) regulations of the United States. The warnings presented below in this
Safety Data Sheet (SDS) comply with the 2012 OSHA Hazard Communication Standard (GHS Globally Harmonized System of Classification and Labeling). The requirements for the labeling
and warnings of FDA products may differ from those required for GHS based hazard
communication.
SECTION 2. HAZARDS IDENTIFICATION
Emergency Overview
Appearance
Colour
Odour
viscous, gel
colourless, clear
citrus
GHS Classification
Flammable liquids
Eye irritation
: Category 3
: Category 2A
GHS label elements
Hazard pictograms
:
Flame
Signal word
Exclamation
mark
: Warning
1 / 12
SAFETY DATA SHEET
ZEP INSTANT HAND SANITIZER GEL
Version 2.10
Revision Date 07/09/2020
Print Date 10/26/2020
Hazard statements
: H226 Flammable liquid and vapour.
H319 Causes serious eye irritation.
Precautionary statements
: Prevention:
P210 Keep away from heat, hot surfaces, sparks, open flames
and other ignition sources. No smoking.
P233 Keep container tightly closed.
P240 Ground and bond container and receiving equipment.
P241 Use explosion-proof electrical/ ventilating/ lighting
equipment.
P242 Use only non-sparking tools.
P243 Take precautionary measures against static discharge.
P264 Wash skin thoroughly after handling.
P280 Wear protective gloves/ eye protection/ face protection.
Response:
P303 + P361 + P353 IF ON SKIN (or hair): Take off
immediately all contaminated clothing. Rinse skin with water.
P305 + P351 + P338 IF IN EYES: Rinse cautiously with water
for several minutes. Remove contact lenses, if present and
easy to do. Continue rinsing.
P337 + P313 If eye irritation persists: Get medical advice/
attention.
P370 + P378 In case of fire: Use dry sand, dry chemical or
alcohol-resistant foam to extinguish.
Storage:
P403 + P235 Store in a well-ventilated place. Keep cool.
Disposal:
P501 Dispose of contents/container in accordance with local
regulation.
SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS
Substance / Mixture
:
Mixture
Hazardous components
Chemical name
CAS-No.
Concentration [%]
ethanol
64-17-5
>= 50 - < 70
The exact percentages of disclosed substances are withheld as trade secrets.
SECTION 4. FIRST AID MEASURES
General advice
: Move out of dangerous area.
Show this safety data sheet to the doctor in attendance.
Do not leave the victim unattended.
If inhaled
: If unconscious, place in recovery position and seek medical
advice.
If symptoms persist, call a physician.
2 / 12
SAFETY DATA SHEET
ZEP INSTANT HAND SANITIZER GEL
Version 2.10
Revision Date 07/09/2020
Print Date 10/26/2020
In case of skin contact
: This product is formulated for use on skin. Discontinue use if
irritation and redness develop.
In the workplace, if a significant exposure or spill occurs on
the skin, immediately wash off with plenty of water.
In case of eye contact
: Remove contact lenses.
Protect unharmed eye.
Keep eye wide open while rinsing.
If eye irritation persists, consult a specialist.
If in eyes, rinse with water for 15 minutes.
If swallowed
: Keep respiratory tract clear.
Never give anything by mouth to an unconscious person.
If symptoms persist, call a physician.
DO NOT induce vomiting unless directed to do so by a
physician or poison control center.
Most important symptoms
and effects, both acute and
delayed
: Effects are immediate and delayed.
Symptoms may include irritation, redness, pain, and rash.
Causes serious eye irritation.
Review section 2 of SDS to see all potential hazards.
Notes to physician
: Treat symptomatically. Symptoms may be delayed.
SECTION 5. FIREFIGHTING MEASURES
Suitable extinguishing media
: Alcohol-resistant foam
Carbon dioxide (CO2)
Dry chemical
Water spray jet
Unsuitable extinguishing
media
: High volume water jet
Specific hazards during
firefighting
: Do not allow run-off from fire fighting to enter drains or water
courses.
Hazardous combustion
products
: Carbon dioxide (CO2)
Carbon monoxide
Smoke
: Use extinguishing measures that are appropriate to local
circumstances and the surrounding environment.
Specific extinguishing
methods
Further information
: Collect contaminated fire extinguishing water separately. This
must not be discharged into drains.
Fire residues and contaminated fire extinguishing water must
be disposed of in accordance with local regulations.
For safety reasons in case of fire, cans should be stored
separately in closed containments.
Use a water spray to cool fully closed containers.
Special protective equipment
for firefighters
: Wear self-contained breathing apparatus for firefighting if
necessary.
3 / 12
SAFETY DATA SHEET
ZEP INSTANT HAND SANITIZER GEL
Version 2.10
Revision Date 07/09/2020
Print Date 10/26/2020
SECTION 6. ACCIDENTAL RELEASE MEASURES
Personal precautions,
protective equipment and
emergency procedures
: Material can create slippery conditions.
Use non-slip safety shoes in areas where spills or leaks can
occur.
Refer to protective measures listed in sections 7 and 8.
Beware of vapours accumulating to form explosive
concentrations. Vapours can accumulate in low areas.
Environmental precautions
: Prevent product from entering drains.
Prevent further leakage or spillage if safe to do so.
If the product contaminates rivers and lakes or drains, inform
respective authorities.
Methods and materials for
containment and cleaning up
: Soak up with inert absorbent material (e.g. sand, silica gel,
acid binder, universal binder, sawdust).
Sweep up or vacuum up spillage and collect in suitable
container for disposal.
SECTION 7. HANDLING AND STORAGE
Advice on safe handling
: Avoid formation of aerosol.
For personal protection see section 8.
Smoking, eating and drinking should be prohibited in the
application area.
Take precautionary measures against static discharges.
Provide sufficient air exchange and/or exhaust in work rooms.
Open drum carefully as content may be under pressure.
Dispose of rinse water in accordance with local and national
regulations.
Avoid contact with eyes.
Conditions for safe storage
: No smoking.
Keep container tightly closed in a dry and well-ventilated
place.
Containers which are opened must be carefully resealed and
kept upright to prevent leakage.
Observe label precautions.
Materials to avoid
: Strong oxidizing agents
SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Components with workplace control parameters
Components
CAS-No.
Value type
(Form of
exposure)
ethanol
64-17-5
TWA
TWA
TWA
4 / 12
Control
parameters /
Permissible
concentration
1,000 ppm
1,000 ppm
1,900 mg/m3
1,000 ppm
Basis
ACGIH
NIOSH REL
OSHA Z-1
SAFETY DATA SHEET
ZEP INSTANT HAND SANITIZER GEL
Version 2.10
Revision Date 07/09/2020
TWA
STEL
PEL
Engineering measures
Print Date 10/26/2020
1,900 mg/m3
1,000 ppm
1,900 mg/m3
1,000 ppm
1,000 ppm
1,900 mg/m3
OSHA P0
ACGIH
CAL PEL
: No special ventilation requirements necessary during product
use. In the workplace or during a spill, utilize effective
exhaust ventilation.
Personal protective equipment
Respiratory protection
Hand protection
Remarks
: No personal respiratory protective equipment normally
required.
In the workplace- If a significant exposure or spill occurs, use
respiratory protection unless adequate local exhaust
ventilation is provided or exposure assessment demonstrates
that exposures are within recommended exposure guidelines.
: This product is formulated for use on skin. No special
protection is required.
Eye protection
: Eye protection is not required while sanitizing with this
product.
In the workplace, the use of safety glasses is recommended to
avoid eye exposure during the handling of containers or
during spill clean-up.
Skin and body protection
: No special protection is required.
Hygiene measures
: Wash hands before breaks and at the end of workday.
SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance
: viscous, gel
Colour
: colourless, clear
Odour
: citrus
Odour Threshold
: No data available
pH
: 7-8
Melting point/freezing point
: No data available
Boiling point
: No data available
Flash point
: 23.33 ¡ãC
Method: closed cup
5 / 12
................
................
In order to avoid copyright disputes, this page is only a partial summary.
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.
Related download
- safety data sheet alcohol based hand sanitizer
- safety data sheet hand sanitizer gel promo brands
- safety data sheet abe hand sanitizer
- purell advanced instant hand sanitizer
- purell hand sanitizer
- safety data sheet medline industries
- hand sanitizer msds haden exports
- purell advanced hand sanitizer gel
- safety data sheet zep instant hand sanitizer gel
- purell advanced hand sanitizer sanitizing gel
Related searches
- fda hand sanitizer recall
- assured instant hand sanitizer made in china
- assured hand sanitizer 8 oz
- is assured hand sanitizer safe
- 1 oz hand sanitizer bulk
- assured hand sanitizer company
- is hand sanitizer made in china safe
- hand sanitizer from china safe
- buy hand sanitizer in bulk
- toxic hand sanitizer list
- list of hand sanitizer not to use
- fda hand sanitizer warning list