Interference-aware Precoding Schemes for Multicell MIMO ...



Submission Guideline for ICT Express

Author’s Full Name 1, Authors’ Full Name 2*

1 Department, Organization, City, Country (e-mail: email1@)

2 Department, Organization, City, Country (e-mail: email2@)

* Corresponding author

Abstract

The abstract should be self-contained (contains no footnotes). It should concisely state what was done, how it was done, principal results, and their significance. It should be around 75 to 100 words for all forms of publication. The abstract should be written as one paragraph and should not contain displayed mathematical equations, tabular materials, or numbered references. At the end of abstract, index terms should be given in 3 to 5 keywords and in alphabetical order, separated by commas.

Index Terms: ICT Express, Submission guideline, Template.

I. Introduction

Submitted letters should be concisely written in English and the length should be no longer than 4 pages in two-column format. Manuscript must be submitted by one of the authors of the manuscript, and should be submitted by anyone on their behalf. The submitting author takes responsibility for the article during submission and peer review. Authors are required to upload the manuscript as a PDF file at the time of submission. Using MS Word template, the length of the letter should not exceed 6 pages including title, list of authors, abstract, figures, tables, and references. Figures and tables are allowed up to 4 in total. Each manuscript must be accompanied by a 75 to 100 word abstract and a list of 3 to 5 keywords. Submitted letters violating these guidelines will be returned to the authors without being reviewed.

II. Manuscript Preparation

A. Format of Initial or Intermediate Congtributions

The main document with the manuscript text, figures, and tables should be prepared in an MS World or LaTeX format in English. The manuscript should be written in 10-point font with single line spacing on A4 sized (21.0 ( 29.7 cm) paper with 2.5 cm margins on the top, bottom, right, and left. The standard order of sections in the manuscript is title page, abstract, introduction, system model and methods, results, discussion, references, figures with figure legends, and tables with table legends. Validation to this format may be allowed. Number all manuscript pages starting with the title page as page 1. A single file is permitted for initial submission, but figures and tables are uploaded separately.

B. Title Page

The Title page should include a full title, running title (no more than 40 characters in length) of the article and authors' information. The Title should be as concise as possible but informative enough to facilitate information retrieval, but not use the acronymic words. Authors' information should contain the names, affiliations including the name of the country and full contact information (including address, telephone number, fax number, and e-mail) should be provided.

A 'corresponding author' for reprints should be indicated and presentation history (name of the meeting and date) at a meeting should be included if relevant. 

C. Text

The text is recommended to be arranged in this order, if possible: Introduction, System Model and Methods, Result, Discussion, and Conclusions. In Introduction, the purpose and the background should be written simply and lucidly. In System Model and Methods, the methodology should be written precisely so that others may use some or all of the methods in another study or judge the scientific merit of your work. In Result, a detailed description of the study results should be objectively presented, in an orderly and logical sequence using both text and illustrative materials (Tables and Figures), In Discussion and Conclusions, author's interpretation of the results, author's opinion and process of inducing conclusion should be written simply.

1) Text Section Heading

There are four levels of section headings with established specifications: primary; secondary; tertiary; and quaternary heads. Enumeration of section heads is required. The section headings are as follows. Primary headings are enumerated by Roman numerals and centered above the text. Secondary headings are enumerated by capital letters followed by periods, upper and lower case, and italic. Tertiary headings are enumerated by Arabic numerals followed by parentheses. They are indented one and run into the text in their sections, italic, upper and lower case, and followed by a colon. Quaternary heading: Quaternary headings are [pic]identical to tertiary headings, except that they are indented two ems, lower case letters are used as labels, and only the first letter of the heading is capitalized.

2) References in Text

References should be obviously related to documents. References should be numbered consecutively in the order in which they are first mentioned in the text. Each reference should be cited as [1, 4, 7], or [6-9]; Kim [3] and Jang and Lee [5]; Park et al. [6].

3) Text Equations

The Equations should be punctuated and aligned to bring out their structure and numbered on the right as

[pic] (1)

Mathematical operation signs indicating continuity of the expression should be placed at the left of the second and succeeding lines. Use x rather than a centered dot, except for scalar products of vectors. The solidus (/) should be used instead of built-up fractions in running text, and in display wherever clarity would not be jeopardized. Use “exp” for complicated exponents. Furthermore, the Notation must be legible, clear, compact, and consistent with standard usage. All unusual symbols whose identity may not be obvious must be identified the first time they appear, and at all subsequent times when confusion might arise. Superscripts are normally set directly over subscripts; authors should note where readability or the meaning requires a special order. In the text, numbers should be Arabic numerals, except when beginning a sentence. Numbers greater than 999 should have commas, e.g., 13,970. The 24-hour system is used to indicate time, e.g., 18:00 hr. If you are using Word for Math, use either the Microsoft Equation Editor or the MathType add-on () for equations in your paper. “Float over text” should not be selected.

4) Units and Abbreviations

Units of measure should be presented according to the International System (SI) of Units. If other units are mentioned, please give their equivalent in SI.

Abbreviations must be used as an aid to the reader, rather than as a convenience of the author, and therefore their use should be limited. Acronyms and abbreviations should be defined the first time they are used in text.

5) Tables

Each Table should be numbered with Arabic numerals in the order of their appearance in the text. Tables should have a concise and informative title with the table [pic][pic]content between horizontal lines. Vertical lines are not used. The structure should be clear, with simple column headings giving all units. A table should not exceed one page when printed. Use lower case letters in superscripts a, b, c ... for special remarks. Unaltered computer output and notation are generally unacceptable. An example of a table is given in Table 1.

6) Figures

Figures are numbered consecutively in the sequence mentioned in the text and must have a caption written in one paragraph style. The caption should contain an explanation of all abbreviations and symbols used, and indicate the size value of lines or bars unless shown directly on the figure. An example of a figure is given in Fig. 1. The Figure number should be placed at the lower-left corner of each figure, and the numbering order must be from left to right, and from upper to lower. Citations of figures in the text or parentheses are abbreviated, e.g., Fig. 1, Figs. 1 and 2, Figs. 1-3, (Fig. 1), (Figs. 1 and 2), (Figs. 1-3). When the text refers to both figures and tables, they should be mentioned in parentheses, e.g., (Table 1; Fig. 2) and (Tables 1-3; Figs. 4-6).

Acknowledgments

Persons or institutes who contributed to the papers but not enough to be coauthors may be introduced. Financial support, including foundations, institutions, pharmaceutical and device manufacturers, private companies, intramural departmental sources, or any other support should be described.

Appendix

Authors including an appendix section should do so before References section. Multiple appendices should be numbered with capital letters A, B, etc.

References 

Journal Articles

1] H. Kwon, K. Kim, and C. Lee, “The unified UE baseband modem hardware platform architecture for 3GPP specification,” J. Commun. Net., vol. 13, no. 1, pp. 70-76, Feb. 2011.

2] T. Roos, P. Myllymaki, and H. Tirri, “A statistical modeling approach to location estimation,” IEEE Trans. Mobile Comput., vol. 1, no. 1, pp. 59–69, 2002.

3] T. Han, I. Choi, and S. Kang, “A novel test access mechanism for parallel testing of multi-core system,” IEICE Electron. Express, Mar. 2014. doi:10.1587/elex.11.20140093

Books & Book Chapters

4] H. Liu and G. Li, OFDM-Based Broadband Wireless Networks: Design and Optimization. Hoboken, NJ: Wiley-Interscience, 2005.

5] J. L. Hennessy and D. A. Patterson, “Instruction-level parallelism and its exploitation,” in Computer Architecture: A Quantitative Approach, 4th ed. San Francisco, CA: Morgan Kaufmann Pub., ch. 2, 2007, pp. 66-153.

6] G. O. Young, “Synthetic structure of industrial plastics,” in Plastics, vol. 3, Polymers of Hexadromicon, J. Peters, Ed., 2nd ed. New York: McGraw-Hill, 1964, pp. 15-64.

Conference Proceedings

7] T. L. Marzetta, “How much training is required for multiuser MIMO?,” in Proc. Asilomar Conf. Signal. Syst. Comput., Pacific Grove, CA, 2006, pp. 359–363.

8] J. Arrillaga and B. Giessner, “Limitation of short-circuit levels by means of HVDC links,” presented at the IEEE Summer Power Meeting, Los Angeles, CA, July 12–17, 1990.

Dissertations

9] J. O. Williams, “Narrow-band analyzer,” Ph.D. dissertation, Dept. Elect. Eng., Harvard Univ., Cambridge, MA, 1993.

Technical Reports

10] J. H. Davis and J. R. Cogdell, “Calibration program for the 16-foot antenna,” Elect. Eng. Res. Lab., Univ. Texas, Austin, Tech. Memo. NGL-006-69-3, Nov. 15, 1987.

Online Sources

11] Malardalen Real-Time Research Center. The worst-case execution time (WCET) analysis project [Internet]. Available:

12] RealVNC Ltd. Remote control software [Online]. Available: http://

13] R. J. Vidmar. (1992, Aug.) On the use of atmospheric plasmas as electromagnetic reflectors. IEEE Trans. Plasma Sci. [Online]. 21(3), pp. 876–880. Available:

-----------------------

Table 1. An example of a table.

|An example of a column heading |Column A |Column B |

|And an entry |1 |2 |

|And another entry |3 |4 |

|And another entry |5 |6 |

|And another entry |7 |8 |

[pic]

(a)

[pic]

(b)

Figure 1. Example of a figure. (a) First. (b) Second.

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download