Repair and Installation Help from



Repair and Installation Help from

[pic]

123 E. Maple Street

Jeffersonville, Indiana 47130

Installation of the adjustable resistor 1977-1982

To install the adjustable resistor you must first remove the center dash cluster from your car. Instructions to this can be found on our site at the following link: Start on page 3 and read to page 5.

HU 78-82 Dash Pad removal instructions.

Once you have the dash cluster out of the car you will want to remove the five bulbs, and four nuts as shown in figure 1.

[pic][pic]

Remove the two resistor nuts, remove the porcelain resistor and install new resistor (wires up) as shown in figures 3 and 4. Wire points must be upward!

[pic]

Reinstall printed circuit board making sure to route the resistor wire under the circuit board as shown in figures 5 and 6. Take extra care to keep the new resistor harness from being pinched by the circuit board nut shown in figure 6.

[pic]

When properly installed, your gauge cluster should appear like the one below.

[pic][pic]

Willcox Inc. 2014 all rights reserved.

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download