Shift Lock Control Solenoid Replacement



Shift Lock Control Solenoid Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution in the Preface section.

[pic]

[pic]

1. Disconnect the negative battery cable.

2. Remove the floor console .

3. Disconnect the wiring harness connectors from the shift control lever.

[pic]

[pic]

4. Loosen the control cable adjusting nut.

5. Disconnect the control cable from the shift control lever assembly.

[pic]

[pic]

6. Remove the shift control lever assembly mounting bolts.

7. Remove the shift control lever assembly.

[pic]

[pic]

8. Remove the two shift lever control knob retaining screws, the then knob from the assembly.

9. Carefully remove the shift select cover from the lever assembly.

[pic]

[pic]

10. Remove the shift lock solenoid retaining screws.

11. Remove the solenoid from the assembly.

Installation Procedure

1. Install the shift lock solenoid on the assembly.

[pic]

[pic]

2. Install the shift lock solenoid retaining screws.

3. Carefully install the shift select cover to the lever assembly.

4. Install the shift lever control knob, then the retaining screws.

Notice: Refer to Fastener Notice in the Preface section.

[pic]

[pic]

5. Install the shift control lever assembly and mounting bolts.

Tighten

Tighten the shift control lever assembly mounting bolts to 8 N·m (71 lb in).

[pic]

[pic]

6. Connect the control cable to the shift control lever assembly.

7. Tighten the control cable adjusting nut.

Tighten

Tighten the control cable adjusting nut to 8 N·m (71 lb in).

[pic]

[pic]

8. Connect the harness connector.

9. Adjust the control cable.

Range Selector Lever Cable Adjustment

Adjustment Procedure

The various shift control cable positions must match at the shift control lever in the vehicle and at the selector lever on the transaxle to provide proper transaxle shifting.

Place the shift control lever in the park (P) position and check the selector lever connection to verify that it is in the forward most position. If it is not, the following adjustment must be performed:

Caution: Refer to Battery Disconnect Caution in Cautions and Notices.

[pic]

[pic]

1. Disconnect the negative battery cable.

2. Remove the trim panel from the floor console. Refer to Front Floor Console Replacement in Instrument Panel, Gages, and Console.

3. Place the shift control lever in the park (P) position.

[pic]

[pic]

4. Loosen the control cable adjusting nut.

[pic]

[pic]

5. Move the park/neutral position (PNP) switch lever counterclockwise until stopping the lever.

Notice: Refer to Fastener Notice in Cautions and Notices.

[pic]

[pic]

6. Pull the shift control cable until it is tight and tighten the control cable adjusting nut.

Tighten

Tighten the control cable adjusting nut to 8 N·m (71 lb in).

................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download