TEK-BOT IR REMOTE CONTROL TROUBLE SHOOTING GUIDE
TEK-BOT IR REMOTE CONTROL TROUBLE SHOOTING GUIDE
| |IS IT ON? Otherwise check the battery voltage. The transmitter should be above 8.0V and the receiver above|
|The LED does not glow |6.0V. Replace transmitter battery or charge tek-bot battery. |
|The LED glows RED |The power indicator LED should glow GREEN. If the LED glows RED the positive and negative power terminals |
| |are reversed. Simply reverse the power wire and the LED should again glow green. |
|The tek-bot will only move in one |The DR, ER, DL, DR outputs of the receiver board must be properly connected to the motor controller board. |
|direction |Make certain these pins line up correctly on each board. |
|The tek-bot keeps moving after I release |Make certain J3 (jumper 3) is in place. This toggles the receiver between momentary and latch mode. |
|a button | |
|The LED is GREEN but it doesn’t work |Check to be certain all of the correct components are in place. Recheck component values and orientation to|
| |be certain all components are correctly installed. Pay special attention to the orientation of the diode |
| |and the IC |
|The LED is GREEN but it doesn’t work |The address DIP-switches on the transmitter and receiver must be set to the same address. Make certain the |
| |switches are set exactly the same. |
|The LED is GREEN but it doesn’t work |Jumper pins J2 must be connected to the IR and center pin. If the jumper is on the RF to center pin the |
| |receiver will not function. |
|The LED is GREEN but it doesn’t work |Another common problem is “cold solder joints”. This means that the heat from the solder iron was not |
| |applied for a long enough time to efficiently saturate the connection with solder. The solution is to go |
| |back over every connection and re-solder every joint applying heat until the joint is fully saturated |
|The LED is GREEN but it doesn’t work |Make certain all pins of the IR detector are in the socket. It is very common for the center pin to miss |
| |the socket. |
|The LED is GREEN but it doesn’t work |Check that the motor control board had power. Use a multi-meter to test the voltage at the supply pins. |
Still having problems? Contact:
Ken Townsend
(402) 554-2927
ktownsend@mail.unomaha.edu
Ben Barenz
(402) 554-
bbarenz@mail.unomaha.edu
................
................
In order to avoid copyright disputes, this page is only a partial summary.
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.
Related download
- section 26 24 19 motor control centers
- afd vfd medium voltage sc9000 specification guide 16349b
- psu electrical safety program
- 1968 corvette wiper system
- t3x or t3xi treadmill troubleshooting
- section 16480
- low voltage motor control centers freedom guide spec
- battery control center justanswer
- tek bot ir remote control trouble shooting guide
- control of hazardous mechanical energy
Related searches
- spectrum remote control issues
- lg tv remote control instructions
- remote control register vent
- lg remote control manual
- comcast remote control replacement
- lg remote control won t work
- samsung sound bar remote control manual
- xfinity remote control guide
- xfinity remote control user manual
- remote control hvac damper
- lg remote control problem
- xfinity tv remote control setup