Cutter not Being Recognized by Computer
Cutter not Being Recognized by Computer
1-1 Driver
Verify the driver is installed. Review the proper driver installation guide for your cutter at:
? ? Under the "Drivers & Downloads" Section
2-1 Connection
Check the USB cable and make sure it is plugged in to the computer and the cutter.
2-2 Connection
Verify the connection on both ends is tight.
If the cable is moving around a lot in the plug, it may not be getting a good connection.
2-3 Connection
If the computer is still not recognizing the cutter, move the USB cable to another port on the computer.
The cable should be plugged directly into a computer USB port, not an expanded USB box.
................
................
In order to avoid copyright disputes, this page is only a partial summary.
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.
Related download
- general uls troubleshooting guide lst group
- common copier printer sharpusa
- hid fargo hdp5000 hdp5600 troubleshooting guide
- cutter not being recognized by computer
- troubleshooting guide hp envy 6200 7100 7800
- hp printers no connection after router or wi fi settings
- do not connect the printer to your computer s usb port
- setup is unable to find my printer after connecting it
- ge mega2560 mainboard使用手册 geeetech
- printer faq us
Related searches
- not being truthful synonym
- word for not being there
- not being able to understand someone
- has not being or been
- synonyms for not being yourself
- word for not being enough
- not being truthful
- word for not being used
- word for not being truthful
- not being good enough synonym
- poems not being good enough
- poems about not being enough