WHY EMPLOYEES DO NOT FOLLOW PROCEDURES
[Pages:35]Revista Empresarial Inter Metro / Inter Metro Business Journal
Fall 2007 / Vol. 3 No. 2 / p. 15
WHY EMPLOYEES DO NOT FOLLOW PROCEDURES
By Axel A. Santiago Mechanical Engineer Master in Business Administration Inter American University Metropolitan Campus Abstract Many organizations dedicate considerable efforts in designing reliable management systems in an attempt to reduce variability in production and improve the potential for superior quality, safety and productivity. These systems operate under the assumption that employees will follow the established rules and procedures. However, when human factors are not considered in the system, errors and violations made by employees can put the entire management system at risk. There are many factors involved in the reason why employees do not follow established procedures. These factors can be very complex and involve organizational, management, motivational, job design, equipment, and environmental considerations, among others. This paper will evaluate these factors and the underlying environment which promotes procedure violations, through the review of publications and previous studies on human error. By considering these factors, measures can be adopted for the prevention and minimization of human errors during execution of operational procedures.
Revista Empresarial Inter Metro / Inter Metro Business Journal
Fall 2007 / Vol. 3 No. 2 / p. 16
Why Employees do not Follow Procedures
Human errors account for most of the industrial incidents, resulting in considerable losses to the organizations. Among the several types of human errors, violations of established procedures are of particular interest. Violations can be defined as any deliberate deviation from the established procedures, instructions or regulations introduced for the safe or efficient operation of a process or maintenance of equipment. This applies to all levels, from operators to high level management. Departure from established procedures can be either unintentional or deliberate, where the actions (though not the possible bad consequences) were intended. However, violations are usually not willful acts of sabotage or vandalism. Contrary to expectations, procedure violations are usually the result of well intentioned employees attempting to get the job done, rather than by those who are only interested in their own comfort. It involves a conscious decision based on the perceived probability of the risk of accident or incident and of the detection and its consequences, as opposed to personal gain. While the deliberate failure to follow known procedures is called a violation when it goes wrong, when it succeeds it may be called the exercise of initiative.
The trend of procedure violations in the workplace must be carefully evaluated and addressed by management. Apart from the obvious potential problems to result in unpleasant consequences in product quality and efficiency of the process, violations increase the likelihood of an accident. The reasons for these potential consequences are:
Revista Empresarial Inter Metro / Inter Metro Business Journal
Fall 2007 / Vol. 3 No. 2 / p. 17
Violations take people outside the boundaries of safe working practices, making the environment less forgiving to errors. In other words, violations remove one layer of defense which aims to ensure predictable and safe working practices.
Violations can themselves be errors when the individual does not know or understand the rule. This lack of understanding is dangerous in itself, because while not appreciating the risk, people often fail to protect themselves.
Violations can take people into new or unpracticed situations, in which the person is more likely to make an error.
Violations are breaches in the last line of defense. Procedures are barriers put in place because other alternatives, such as design, hardware and avoidance of the problem, are not possible.
Human Error and Violations
Violation fall under the category of human error, but not all human errors are violations. It is important to understand both concepts since both play an important role in the reason why procedures may not be followed.
In its basic definition, error is the failure of planned actions to achieve their desired goal. There are basically two ways in which this failure can occur:
The plan is adequate but the associated actions do not go as intended. Actions deviate from the current intention. These are failures of execution and are commonly termed
Revista Empresarial Inter Metro / Inter Metro Business Journal
Fall 2007 / Vol. 3 No. 2 / p. 18
slips and lapses. Slips relate to observable actions and are associated with attention failures. Lapses are more internal events and relate to failures of memory.
The actions may go entirely as planned but the plan itself is inadequate to achieve its intended objective. These are failures of intention, known as mistakes. Here, the failure lies at a higher level: with the mental processes involved in planning, formulating intentions, judging and problem solving. Slips and lapses occur during the largely automatic performance of some routine task, usually in familiar surroundings. They are almost invariably associated with some form of attention capture, either distraction from the immediate surroundings or preoccupation. They are also provoked by change, either in the current plan of action or in the immediate surroundings.
Meister (1977) classified errors further into four major groupings:
Performance of a required action incorrectly
Failure to perform a required action (omission error)
Performance of a required action out of sequence (combined commission/omission error)
Performance of a non-required action (commission error)
Errors are not causes, they are consequences. All mishaps have both a context in which they occur and a chain of events from which they appear to have arisen (Tasker, 2000). This chain of causes involve the individual psychological factors (momentary inattention, forgetting, haste, etc), which are the last and often the least manageable link. Distraction, momentary
Revista Empresarial Inter Metro / Inter Metro Business Journal
Fall 2007 / Vol. 3 No. 2 / p. 19
inattention, forgetting, losing the picture, preoccupation and fixation are entirely natural human reactions to the kind of working environment present in a typical workplace.
So far we have mentioned three forms of human error: slips, lapses, and mistakes. The fourth major form of human error is violations. Violations are distinguished from the more ordinary forms of error because there is the intent not to follow the rules; both the action and the specific behaviors are intended, unlike mistakes where the action may be intended, but the behavior is unintended in the light of the possible outcomes. Most forms of human error are not only unintentional; they can also be detected and recovered from. This means that someone who makes a simple slip or even a lapse can often detect that they have done so and take appropriate corrective action. When you take a wrong turning off a road, this is usually quickly obvious and the route to recovery simple. Mistakes are harder, but even here it may be possible to put things right once someone discovers that they are acting mistakenly. A mistaken choice of route to avoid a traffic jam may turn out to be eventually just a larger mistake if faced with an even larger jam. But even, then some recovery may be possible, even if detection of the mistake takes longer. Violations, on the other hand, are intended, although not because the violator intends harm. There is a certain correlation between the types of error, the existence and effectiveness of techniques for their avoidance and the opportunity for harm (Hudson, Verschuur, Parker & Lawton, n.d.).
Most slips are benign and, because they are often quickly detected, frequently do not lead to damage or injury. Any system that is so designed that a slip, such as selection of the wrong one of two identical-looking buttons on a control panel, leads to a disastrous outcome is unacceptable. Such systems should have been identified and rectified by a
Revista Empresarial Inter Metro / Inter Metro Business Journal
Fall 2007 / Vol. 3 No. 2 / p. 20
sound management system. As slips are caused by factors such as haste and divided attention, good work planning is also a highly effective remedy.
Lapses are more dangerous because they may be missed. It is harder to spot that you have not done something. Forgetting to replace a gasket, failing to tighten a flange, missing a vital isolation check, are all examples of lapses. The problem may be compounded by the persons thinking that they have done the job completely, so an extra round of checks is not conducted. Lapses are especially dangerous in maintenance, where a problem may lie unnoticed until it is too late. Good management systems can require checks and balances for safety-critical activities, which forms one type of defense against the lapse.
Mistakes are even more dangerous than lapses because those making a mistake think they are doing the right thing. They can be so sure of themselves that evidence telling them they are wrong is ignored. A mistake, such as failing to understand a pattern of alarms and deciding what to do on the wrong assumption, leads to performing the wrong corrective actions; it may be the first explosion that signals that a mistake was underway. Management systems will find mistakes harder to correct, but good training, supervision and support certainly help reduce the chance of making mistakes.
Violations are most dangerous of all. They often represent a quite deliberate intention not to follow safety or other procedures which put everyone at risk. Management systems are not typically constructed with violation in mind and only truly inherentlysafe systems could be automatically expected to survive all sorts of violations.
Revista Empresarial Inter Metro / Inter Metro Business Journal
Fall 2007 / Vol. 3 No. 2 / p. 21
Violations differ from the other types of errors in a number of important ways (Reason, 2005).
Whereas errors arise primarily from informational problems (forgetting, inattention, incomplete knowledge, etc), violations are more generally associated with motivational problems (low morale, poor supervisory examples, perceived lack of concern, the failure to reward compliance and sanction non-compliance, etc).
Errors can be explained by what goes on in the mind of an individual, but violations occur in a regulated social context.
Errors can be reduced by improving the quality and delivery of the necessary information within the workplace. Violations generally require motivational and organizational remedies.
Types of Violations
According to Hudson et al. (n.d.), there are five main violation types:
Unintentional violations
Erroneous or unintentional violations occur for two main reasons. First, they arise from procedures which are written in an attempt to control behavior that is impossible for the employee to control (e.g. do not slip or remain in control of your vehicle at all times). Second, unintentional violations may occur when employees do not know or understand the rules. This may be particularly relevant to new employees or when completing tasks that require adherence to a large number of rules. Strictly speaking, the definition of violation requires that deviation is
Revista Empresarial Inter Metro / Inter Metro Business Journal
Fall 2007 / Vol. 3 No. 2 / p. 22
deliberate or intentional. However, from an organizational perspective, it is important that the unintentional violation of formal procedures be avoided.
Routine violations
Violations of this kind, as their name implies, are common practice. They often occur with such regularity that they become automatic and unconscious behavior, and they are recognized as such by the individual only if questioned. Such deviations from formal working practices are often perceived by employees to involve little risk and are accepted by the particular work group as the normal way of doing the job. In this case, violating the rule has become the group norm.
Situational violations
These violations occur as a result of factors dictated by the employees immediate work space or environment, which make it difficult for the employee not to commit a violation. Factors such as time pressure, lack of supervision, unavailability of equipment and insufficient staff all have implications in terms of situational violations (e.g. when an operator improvises because the equipment specified in the procedure is not readily available).
Optimizing violations
This category of violations is related to the nature of the job or the task itself; as optimizing violations frequently occur in an attempt by the employee to make a job more exciting or interesting. These violations are related to the non-functional aspects of work (e.g. a desire to impress or relieve boredom). These violations are also associated with staff testing the safety boundaries of the system. In such cases, staff may actively search for ways of improving
................
................
In order to avoid copyright disputes, this page is only a partial summary.
To fulfill the demand for quickly locating and searching documents.
It is intelligent file search solution for home and business.
Related download
- thyristors triacs ten golden rules for success in your
- principles of fraud examination
- chapter 6 motions resolutions and ordinances
- school children s reasoning about school rules
- why employees do not follow procedures
- the psychological qualities of a good referee
- client identification and verification rules
- alphabetic indexing rules 1 4
- guidelines for observing young children in school
Related searches
- why college is not necessary
- why education is not important
- why college is not for everyone
- why english is not important
- why is teaching not a profession
- why college is not important
- why college should not be free
- why college is not important essay
- why philosophy is not useful
- why education should not be free
- do or do not no try
- why do we follow rules