JJ Custom Uzi Semi-Auto Fixed Stock Installation

Uzi Semi-Auto Carbine Fixed Stock Installation Instructions

Contents: SMG Stock w/relief cut and butt plate Main Bracket Machine Screw w/Washer (2) Replacement Bushing ?-20 Button Head Socket Cap Screw Wood Screw

Remove magazine, clear the rifle, and ensure there is no round in the chamber. For clarity, rifle is picture with dummy barrel installed.

Remove top cover, bolt, striker assembly, striker spring and recoil spring:

Remove ?-20 x ?" socket head cap screw from collapsible stock bracket with a 3/16" allen wrench:

Remove buffer and stock bushing. The buffer slides forward toward the muzzle end of the rifle and lifts out similar to the bolt. It may be necessary to partially thread the ?-20 x ?" socket head cap screw into the bushing a few turns and strike with a hammer to start the buffer moving foward:

Once the buffer is removed install the replacement bushing and reinstall the buffer. The replacement bushing is not as tall and does not protrude from the rear of the receiver once installed:

With the buffer and replacement bushing installed fully rearward, install the main bracket and secure with the ?-20 button head socket cap screw and tighten with a 5/32" allen wrench:

Secure the butt stock with the two machine screws and the remaining wood screw:

Replace bolt, striker, striker spring, recoil spring, and top cover.

 ................
................

In order to avoid copyright disputes, this page is only a partial summary.

Google Online Preview   Download